5590
2Pages

Catalog excerpts

155 Hardman Avenue South, South St. Paul, MN 55075 e-mail: customerservice@holtkoetter.com Please make sure that the following parts for your low-voltage pendant are enclosed: 1. Fixture - this fixture utilizes a 200 Watt, electronic, low-voltage transformer by LIGHTTECH. If you are planning to use a dimmer with this fixture, we recommend using a Lutron ELV (electronic low voltage) style dimmer. 3. Bulbs: 4 each x 50 Watt Halostar IRC by Osram, GY6.35 base Underwriter's Laboratories requires that these IMPORTANT SAFETY INSTRUCTIONS be listed: INSTRUCTIONS PERTAINING TO RISK OF FIRE OR INJURY WARNING: TO REDUCE THE RISK OF FIRE OR INJURY, PLEASE FOLLOW THESE SAFETY INSTRUCTIONS: 1. Turn off power and allow to cool before replacing lamps. 2. Lamp gets HOT quickly! Contact only switch/plug when turning on. 3. Keep lamp away from materials that may burn. 4. Do not touch lamp at any time. Use a soft cloth. Oil from skin may damage lamp. 5. Do not operate luminaire with missing or damaged glass. 6. CAUTION: The recommended replacement bulbs for this fixture are 65 Watt Halostar IRC bulbs by Osram. Use of other brands of unknown quality may cause a risk of Major lamp parts manufactured in Germany by Holtkötter Leuchten GmbH. Bulbs manufactured in Germany by Osram GmbH. Final assembly by Holtkötter International, Inc. in South St. Paul, MN. Low-voltage Pendant Care Instructions Use only a soft, dry cloth to clean. If necessary, a slightly damp, soft cloth can be used to spot clean. Do not use common household cleaners on lamps or fixtures, as the lacquer on the outside of the brass may be damaged as a result. Enjoy your new Holtkötter lamp. Holtkötter® and Holtkötter Leuchten® are registered trademarks of Holtkötter International, Inc. All Rights Reserved.

Open the catalog to page 1

e-mail: customerservice@holtkoetter.com It is recommended that this fixture be installed and hung by a licensed electrician. Installation/Mounting Instructions 1. Disconnect power to the box before installation. 2. Locate and unscrew the three finished nuts (A) holding the finished backplate (B) to the finished mounting hardware (C). 3. Connect the wires from the fixture with the wires in the outlet box according to generally accepted electrical standards. 4. Make an initial height adjustment prior to mounting the fixture to the ceiling. The fixture comes adjusted to approximately one foot...

Open the catalog to page 2

5590 2Pages

Catalog excerpts

All Holtkötter Leuchten catalogs and technical brochures

5590
2Pages