155 Hardman Avenue South, South St. Paul, MN 55075 e-mail: [email protected] Please make sure that the following parts for ceiling 1. Fixture including crossbar strap 3. Bulbs: Westinghouse Fluorescent <¡^b Be sure to turn off the circuit breaker before installing this fixture. It is recommended that this fixture be installed and hung by a licensed electrician. Mounting Instructions (Diagram 1)_ 1. Disconnect power to the outlet box before 2. Loosen screws (A) to release fixture from the 3. Mount the crossbar strap (B) to the outlet box. 4. Connect the wires from the fixture with the wires in the outlet box according to generally accepted electrical standards. 5. Slip the fixture onto the crossbar strap and hand- tighten the two screws to secure the fixture to the Major lamp parts manufactured in Germany by Holtkötter Leuchten GmbH. Bulbs manufactured in Germany by Osram GmbH. Final assembly by Holtkötter International, Inc. in South St. Paul, MN. Energy Star Ceiling Fixture Care Instructions_ Use only a soft, dry cloth to clean. If necessary, a slightly damp, soft cloth can be used to spot clean. Do not use common household cleaners on lamps or fixtures, as the lacquer on the outside of the brass may be damaged as a result. Enjoy your new Holtkötter lamp. Holtkötter® and Holtkötter Leuchten® are registered trademarks of Holtkötter International, Inc. All Rights Reserved.

e-mail: [email protected] 1. Before reconnecting power to the box, install 2. Install each bulb by pushing the bulb in slightly and turning it clockwise. Install the Glass Shade (Diagram 2) 1. Once the bulbs are installed, install the glass 2. Remove the finished disc (C) by unscrewing 3. There are four clips (D) which hold the glass shade in place. One of these clips is 4. Install the glass shade over the three stationary clips. Diagram 2 5. Hold the glass shade against the fixture and turn the fourth clip into place. 6. Reinstall the finished disc (C) by screwing it back into...