155 Hardman Avenue South, South St. Paul, MN 55075 e-mail: [email protected] Please make sure that the following parts for ceiling fixture are enclosed: 1. Fixture including backplate A. Finished Trim Ring (Solid or Dekor) B. Optional plastic washers (to lower the glass if desired) 3S02/2 -120 Watts, total (2 ea x max. 60 Watt) ' 3S03/3 -180 Watts, total (3 ea x max. 60 Watt) . WW 3S0S/S - 300 Watts, total (5 ea x max. 60 Watt) (/W 60 Watt Halopin by Osram / / Be sure to turn off the circuit breaker before installing this fixture. It is recommended that this fixture be installed and hung by a licensed electrician. Mounting Instructions 1. Disconnect power to the outlet box before installation. 2. Loosen screw (A) to release the fixture from the 3. Mount the backplate (B) to the outlet box. 4. Connect the wires from the fixture with the wires in the outlet box according to generally accepted electrical 5. Slip the fixture onto the backplate (B). Using a philips head screwdriver, secure the fixture to the outlet box by Major lamp parts manufactured in Germany by Holtkötter Leuchten GmbH. Bulbs manufactured in Germany by Osram GmbH. Final assembly by Holtkötter International, Inc. in South St. Paul, MN. Ceiling Fixtures Care Instructions_ Use only a soft, dry cloth to clean. If necessary, a slightly damp, soft cloth can be used to spot clean. Do not use common household cleaners on lamps or fixtures, as the lacquer on the outside of the brass may be damaged as a result. Enjoy your new Holtkötter lamp. Holtkötter® and Holtkötter Leuchten® are registered trademarks of Holtkötter International, Inc. All Rights Reserved.

e-mail: [email protected] 1. Before reconnecting power to the box, install the bulbs. 2. Install each bulb (C), being careful not to touch the bulb envelop with bare hands. Hold the bulb and push straight into the socket. [Photos represent a sample of fixture 3505/5. The fixture you are installing may only have 2 (3502/2) or 3 (3503/3) bulbs.) Install the Glass Shade_ 1. Install the glass shade on the fixture, centering the aluminum nut (D) on the fixture. 2. OPTIONAL: If desired, the glass can be lowered by installing the additional plastic washers provided. Prior to installation,...