PRODUCT DATA SHEET – PU 63 PAINT I. CHEMICAL BASE / APPLICATIONS Weather- and UV-resistant polyurethane resin-based finish with solvent. The product is elastic and abrasion resistant. Anti-slip formula suited to playground surfacing. Density g/cm3 – 20°C DIN 53217 Dry. viscosity – 20°C DIN 4mm cut Mixing ratio Red Yellow Green Orange Blue Others to order Pot life Approximately 3 hours at 20°C. The pot life may be reduced by increasing the temperature of the components. III. POLYMERIZATION The paint dries by evaporation of the solvent phase and by chemical reaction between the polyol and the isocyanate. At 20°C, the hardening profile is as follows: Dust dry 1 to 5 hours Tack free 2 to 3 hours Suitable for circulation 12 hours Intensive use 3 to 5 days IV. RECOMMENDATIONS FOR USE In order to ensure optimal adhesion, the surface must be clean and dry, and free from any oil or grease. The hardener B must be carefully mixed with the component A according to the mixing ratio. Ground and air temperature should not fall below + 10°C during polymerization. Only spray on with AIRLESS-type spraying equipment. V. CONSUMPTION Approximately 0.300kg per coat. The exact quantities depend on the type of base. Two crossed coats are necessary. Models, drawings and names are registered. No copy or reprography is permitted without prior written authorization. This manual was reviewed in June 2015 and may be updated; please make sure this is the latest version. FRANCE CONSTRUCTION Sols Sportifs et Techniques ZAC des Bousquets – 165 rue de l’Initiative – F-83390 CUERS TEL.: +33 (0)4 94 14 91 91 – FAX.: +33 (0)4 94 14 93 93 WEBSITE: www.hexdalle.com - E-MAIL: [email protected] Page 1 out of 2

VI. PRECAUTIONS Wear personal protective equipment. Take general protection and hygiene measures: Keep away from food products, drinks and animal feed. Wash hands before each break and when the work is finished. Respiratory protection: In the event of minor or short exposure, wear a filter mask. In the event of intense or long exposure, use a breathing device independent of the ambient air. Wearing a breathing mask is compulsory in insufficiently ventilated premises or in case of spraying. Fresh air mask or, for short duration work, combined filter mask A2 – P2. Protect hands by wearing PVC gloves....