PRODUCT DATA SHEET – CLEANDALLE FC I. BACTERICIDAL DEGREASING CLEANING PRODUCT CLEANDALLE FC is a concentrated product specially designed for treating and cleaning the shockabsorbing tiles or wet floors. Thanks to the wetting power of its surface active agents, CLEANDALLE FC contains no sodium hydroxide, no acid, and no solvent. CLEANDALLE FC IS ENVIRONMENTALLY FRIENDLY II. INSTRUCTIONS FOR USE CLEANDALLE FC can be diluted in water in any proportions; we recommend: Shock treatment: dilute 1 litre in 5 litres of water, Maintenance treatment: dilute 1 litre in 10 to 15 litres of water, Spray the mix onto the surface, leave it to work for about 3 minutes, brush lightly depending on the dirtiness and rinse with a water jet. Consumption: approx. 300g/m² once dilute FOR REMARKABLE RESULTS IN A FLASH III. USE Playgrounds, shock-absorbing tiles or wet floors, sports flooring, synthetic resins, pool decking, porous concrete, etc. IV. PACKAGING 5 litres or 30 litres. V. PHYSICAL PROPERTIES – SAFETY Aspect Density Ph value Flash point Biodegradability Food grade Ecotoxicity Disinfectant Yellow liquid 1.10 11.90 none – non-flammable + 90% order 77/1554 – of 28.12.77 complies with the order 73 138 of 12.02.73 may be toxic for organic organisms if undiluted benzyldimethylammonium chloride The information given in this technical sheet is provided in good faith and intended to advise you. Our company shall not be held liable given the numerous factors beyond our control. Our technical department is at your disposal should you require any further information or advice. Models, drawings and names are registered. No copy or reprography is permitted without prior written authorization. This manual was reviewed in June 2015 and may be updated; please make sure this is the latest version. FRANCE CONSTRUCTION Sols Sportifs et Techniques ZAC des Bousquets – 165 rue de l’Initiative – F-83390 CUERS TEL.: +33 (0)4 94 14 91 91 – FAX.: +33 (0)4 94 14 93 93 WEBSITE: www.hexdalle.com - E-MAIL: [email protected] Page 1 out of 1