Modulating oil burner HLM 35 CV

Modulating oil burner HLM 35 CV

Modulating oil burner HLM 35 CV

Product catalog summary
Overview: The document discusses the features and benefits of the HLM 35 modulating blue flame burner, designed for modern condensing boilers. It highlights the importance of modulation in reducing emissions and improving efficiency in heating systems.
Specifications: The burner operates within a modulation range of 3:1, allowing precise control of the fuel mass flow. It features a volumetric oil dosing system and an electronic fuel/air ratio control system, making it less susceptible to gas inclusions in the oil feed.
Components: Key components include the modulating oil pump (MDP), digital burner control (CM 471), speed adjustable EC blower, and a communication interface (CI 2). The burner is equipped with a silencer and a rotating air intake to reduce noise and improve efficiency.
Efficiency and Emissions: The burner is designed to operate with low electric power consumption, making it economical and environmentally friendly. It reduces nitrogen oxide emissions and minimizes pollutant release by optimizing the start-up process and maintaining a stable flame.
Service and Maintenance: The burner is service-friendly with pluggable electrical components and a design that prevents oil leakage during maintenance. It includes tools for service and provides valuable operational data through a bus system.
Technical Data: The burner operates at a nominal voltage of 230 V ~ 50 Hz, with varying electric power input depending on the blower type and whether the oil preheater is used. It complies with DIN EN 267-A1:2011 standards.
Conclusion: The HLM 35 burner is an ideal solution for modern heating systems, offering high efficiency, low emissions, and ease of maintenance. Its advanced modulation capabilities make it suitable for varying heating loads in residential settings.
See more

Catalog excerpts

Modulating oil burner HLM 35 CV-1

MODULATING BLUE FLAME BURNER |> Electronic fuel /air ratio control system 0 Unsusceptible to gas inclusions in the oil feed 0 Intuitive control and operation system via display |> Engine pump unit with integrated A 0 Low electric power consumption t> Ideal for condensing boilers electronic drive control

 Open the catalog to page 1
Modulating oil burner HLM 35 CV-2

The new climate-friendly oil burner generation The high standard of insulation of modern buildings results in a massive reduction of the heating load. Simultaneously, solar radiation, internal heat sources as well as the heat requirements due to ventilation have a strong impact on the thermal balance of the building. The irregular occurrence of these heat flows leads to strong variations in the heating load. Another consequence of the improved heat insulation is that the power requirements to heat up drinking water increase in relation to the heating load. The power requirement to reload the...

 Open the catalog to page 2
Modulating oil burner HLM 35 CV-3

HLM 35: profitable for the environment and your purse economical The HLM 35 is the ideal burner solution for modern condensing boilers. Its wide modulation range also includes very low firing capacities. The exact dosing of the fuel enables the reliable operation of the burner with little air surplus, which increases the efficiency of the heating system. Thanks to the energy saving magnetic drive and the low fuel turnover the oil pump requires less than 60 W of electrical energy at full load. When the burner has been operated for some time the oil preheater can be switched off, as it is not required...

 Open the catalog to page 3
Modulating oil burner HLM 35 CV-4

[email protected] • www.herrmann-burners.de Horizontal alignment * Other lengths available on request Vertical alignment Model range Low-sulphur heating oil EL pursuant to DIN 51603-1 Heating oil ELA Bio 10 pursuant to DIN SPEC 51603-6, low-sulphur heating oil EL with up to 10% FAME pursuant to the quality requirements of DIN 14214 Components Component Flame monitoring KLC 2002, broad band flame sensor Ignition unit for optical flame monitoring Ignition unit for ionisation flame monitoring ZTÜ, ignition unit with flame monitoring Burner control Communication interface Electric power input...

 Open the catalog to page 4

All Herrmann GmbH u. Co.KG Öl- und Gasbrenner catalogs and technical brochures

  1. HL 60 N/P-S

    2  Pages

  2. HL 60 G/I/K-S

    2  Pages

  3. HL 60 E/F-S

    2  Pages

  4. HLM 35 G

    2  Pages

  5. BURNERS

    24  Pages

  6. HL 120

    1  Page

  7. HLZ 540 A

    1  Page

  8. HLZ 950 L

    1  Page

  9. HLZ 2000 L

    1  Page

  10. HG Z/M 30s

    1  Page

  11. HG 50 A/B

    1  Page

  12. HGZ 120 A-S

    1  Page

  13. HGZ 500 L

    1  Page

*Prices are pre-tax. They exclude delivery charges and customs duties and do not include additional charges for installation or activation options. Prices are indicative only and may vary by country, with changes to the cost of raw materials and exchange rates.