Helvar 22 W SELV constant current LED driver Product code: 5905 22 W 220 - 240 V 50 - 60 Hz • SELV output protection for safety and flexibility in luminaires • Low current ripple, complying with IEEE 1789 recommendation • Suitable for use in emergency lighting applications • Extremely compact dimensions for flexible usage • Ideal solution for Class I and Class II luminaires Functional Description • Adjustable constant current output: 125 mA (default) to 500 mA • Current setting via dip-switches • Overload, open & short circuit protection Mains Characteristics Nominal rated voltage range Rated emergency voltage range AC voltage range DC voltage range Mains current at full load Frequency Stand-by power consumption THD at full power Tested surge protection Tested fast transient protection Insulation between circuits & driver case Mains circuit - SELV circuit Double/reinforced insulation Mains and output - Driver case Double/reinforced insulation Load Output (SELV <60 V) Output current (Iout) Accuracy Ripple Uout (max) (abnormal) EOFI (EL use) 125 mA (default) - 500 mA ± 5 % < 3 %* at s 120 Hz *) Low frequency, LED load: Cree XP-G LEDs 59 V > 0.98 x output current with AC supply Helvar | Helvar Oy Ab, Keilaranta 5 FI-02150 Espoo, Finland. Data is subject to change without notice. www.helvar.com

Current value is adjustable in steps via dip-switch. See dip-switch settings in page 3 for details. Driver performance Typical power factor Total output power (W) Total output power (W) Operating Conditions and Characteristics Absolute highest allowed tc point temperature Tc life (50 000 h) temperature 75 °C Ambient temperature range* –25 °C ... +50 °C* Storage temperature range –40 °C ... +80 °C Maximum relative humidity No condensation Life time (90 % survival rate) 100 000 h, at tc = 65 °C 70 000 h, at tc = 70 °C 50 000 h, at tc = 75 °C *) For other than independent use, higher ta of the controlgear...

Helvar Connections and Mechanical Data Wire size Wire type Wire insulation Maximum driver to LED wire length Weight IP rating 0.2 mm2 - 1.5 mm2 Solid core and fine-stranded According to EN 60598 1.5 m 86 g Connections Note: • Not suitable for load side switching operation In LC22MINI-CC-125-500, the current can be set with dip-switches. With each combination of switch setup, a different output current value can be set. The maximum value can be reached with all switches set to "1" (pushed towards the label, see connections picture above) and minimum with all switches set to "0". The output current...

Information and conformity LC22MINI-CC-125-500 LED driver is suited for built-in usage in Luminaires. In order to have safe and reliable LED driver operation, the LED luminaires will need to comply with the relevant standards and regulations (e.g. IEC/EN 60598-1). The LED luminaire shall be designed to adequately protect the LED driver from dust, moisture and pollution. The luminaire manufacturer is responsible for the correct choice and installation of the LED drivers according to the application and product datasheets. Operating conditions of the LED drivers may never exceed the specifications...