Catalogs >
Hamilton Litestat >
911XTMAB-B

911XTMAB-B
2Pages

Catalog excerpts

911XTMAB-B Cheriton Georgian Antique Brass 1x250W/210VA Resistive/Inductive Trailing Edge Touch Master Multi-Way Dimmer Antique Brass/Black Item Image Primary Range Insert Type Resistive/Inductive Trailing Edge Touch Master Multi-Way Dimmer Plate Finish Cheriton Georgian Antique Brass Insert Colour Antique Brass/Black Dimensions (Nominal) Single: Height = 88.0mm Width = 88.0mm Depth = 10.5mm Fixing Hole Centres Box Fixing = 60.3mm Grid Fixing = N/A Minimum Wall Box Depth Switched Poles Current Rating Maximum Load 250W Resistive 210VA Inductive Min Load 25W/25VA Mains Frequency Earth Terminal Capacity 1 Earth Terminal Capacity 2 Earth Terminal Capacity 3 Earth Terminal Capacity 4 Earth Terminal Capacity 5 Face plate must be earthed Ambient Operating Temperature Recommended Location Maximum Installation Altitude Additional Notes TRAILING EDGE TECHNOLOGY DIMMERS. Are suitable for control of both resistive and inductive loads. When used for dimming low voltage electronic halogen transformers it must be noted that the dimmer controls the primary side of the transformer. Tungsten filament GU10 lamps must be branded with a fuse base. When using mains voltagehalogen lampsdimmers should be de-rated by 25%. When dimming LED lamps de-rated by 75% - please contact our Technical for compatibility. When using mains voltage halogen load transformer - maximum rating is 210VA. NOTE: For multi-way switching a push to make retractive switch should be installed in the other positions. (Note:standard two way switches will not work with this product) 911XTMAB-B - Cheriton Georgian Antique Brass 1x250W/210VA Resistive/Inductive Trailing Edge Touch Master Multi-Way Dimmer Antique Brass/Black

Open the catalog to page 1

911XTMAB-B Cheriton Georgian Antique Brass 1x250W/210VA Resistive/Inductive Trailing Edge Touch Master Multi-Way Dimmer Antique Brass/Black Patents and Trademarks Cheriton Trade Mark No. 2344779 All products listed conform to current British or European standard and the product information is correct at the time of going to press. All accessories are manufactured under an accredited BS EN ISO 9001 : 2015 Quality Management System. Illustrations and diagrams are reproduced within the limitations of reproduction and printing process and are not binding. Due to manufacturing processes we...

Open the catalog to page 2