Catalogs >
HALTON >
JTH

JTH
4Pages

Catalog excerpts

JTH Swirl diffuser unit • Swirl diffuser completed with black adjustable • Horizontal or vertical air supply. Therefore discharge plastic air control blades and plenum with perforated direction can be easily matched with changing equalizing plate. building layouts. • Blades can be manually adjusted to give either • Suitable for supply and exhaust. horizontal or vertical discharge. Therefore discharge • Ceiling integration installation. direction can be easily matched with changing • Supply air jet velocity is effectively reduced due to building layouts. high mixing effect. • Installation using balancing plenum with side • Suited for installation in a modular or monolith ceilings. connection. Connection box made of galvanized • Circular duct connection with rubber gasket. sheet metal. • The device is perfectly suited for installations with Product models & Accessories variable airflow. • Model with sound attenuation material (mineral wool) • Cooperates particularly well with fan-coil units • Measurement and airflow rate adjustment module operating at various speed (variable flow from 25% • Different front plate patterns. MATERIAL AND FINISHING PART Galvanised steel Special colors available Front panel Steel with plastic vanes Mineral wool Coupling sleeve Galvanised steel Duct gasket Rubber compound Polyester fibre available by request

Open the catalog to page 1

ACCESSORIES ACCESSORY Airflow measurement and adjustment unit Adjustment and measurement module for supply airflow rate Airflow adjustment unit Adjustment module for exhaust airflow rate Sides of sound attenuation The highly efficient mixing of the swirl jet produced by the diffuser reduces the end velocity of the jet, as well as the temperature differences very quickly. This allows the air to be blown into the room free from draughts even under extreme conditions (high air exchange or temperature differences). The free cross-section is the same in all louvre positions, so that pressure...

Open the catalog to page 2

We recommend installing the plenum part into the suspended ceiling with metal hangers (not supplied in the delivery) and connected to the ductwork with the spigot equipped with an integral rubber gasket. The supply volume flow rate is determined using the Detach the front panel of the diffuser by removing the measurement and adjustment module MSM. central bolt and pulling it down. Open the front panel and equalisation plate, pass the Wipe the parts with a damp cloth. tubes and control spindle through the equalisation Push the front panel back into place and fasten the plate and side slot of...

Open the catalog to page 3

PRODUCT CODE Halton JTH is a swirl type ceiling diffuser with a square-shaped powder-coated frontplate and a galvanized plenum with perforated balancing plate. The individually adjustable plastic louvres generate high induction swirl jet which ensures effective mixing of the supply air with air present in the room, as well as enables fast temperature decrease D = Diameter of duct connection resulting in low air velocities in the comfort zone. Since the plastic louvres can be adjusted individually, it is allowing users to set the throw pattern according F = Front panel size P = Front panel...

Open the catalog to page 4