Catalogs >
HADLEY >
BrickTie-leaflet

BrickTie-leaflet
4Pages

Catalog excerpts

UltraBrickTie Channel Information Sheet

UltraBrickTie Channel Fixing To Steel Hadley UltraBrickTie Channel is designed to be used with TecTies TTCH series masonry ties to tie masonry cladding to a primary structure through a layer of rigid insulation. Typical applications are timber or light gauge structural steel framing (LGSF) systems, but the system can also be utilised with traditional hot rolled steel frames. Rigid Insulation Wall Tie Length Screw Length Open Cavity Insulation/ Backing Material Depth The system comprises of the Hadley UltraBrickTie 25/14 cold roll-formed steel channel, TecTies TTCH series wall ties and ‘high...

Open the catalog to page 2

* Max centres where insulation is >114mm = 337.5mm. Centres shown achieved equivalent tie type performance (unfactored) to PD6697 Table 12 (M2 mortar) based upon minimum 2.5 per m2. Other restrictions on tie spacing may also apply such as horizontal and vertical spacing, provisions for openings, movement joints, free edges, non-standard facades and extreme wind loads. For all channel tie enquiries please contact TecTies on 01663 749361 or email sales@tecties.co.uk

Open the catalog to page 3

Masonary wall tie classification by end use: Range of Use Hadley UltraBrickTie Reference Typical Application Typical Loading Type 1 (heavy duty) Suitable for most building sizes and types. No height restriction applies. Most sites within the UK. For areas of exceptional wind speeds such as found in the north western fringes - particularly around the coast and for unusual shaped building. The tie provision should always be calculated and advice from a suitably qualified structural engineer should be sought. Type 2 (general purpose) Suitable for small commercial buildings and domestic...

Open the catalog to page 4