DESCR IPTION Base board: throughout Okoume plywood produced from severely selected veneers Quality grade of the outerlayers: Both sides surfaced with a white paintable melamine film of 170 g/m² Guarantee: multiannual on the glue line Average density (IAW EN 323): 500 kg/m3 (+/- 10%) Wall cladding, facades, gables. Constructions in exposed ex- terior environments. Any exterior end-use where the plywood product is going to receive a paint application. Multiannual guarantee on the glue line Formaldehyde release classification (IAW EN 13986): E1 Content of Pentachlorophenol (IAW EN 13986): PCP ≈ 0 ppm Sizes, number of plies & packaging Thicknesses (mm) 22 (11) Other sizes & thicknesses: on request Preservative treatments, fungicide & Insecticide, antitermite: optional on request Cutting & TG processing: optional on request Flat, on intermediate bearers, in an enclosed dry and ventilated building, clear of the ground. As far as storage on site is concerned, provision should be made to cover the panels with an opaque waterproof sheeting with the underside of the stacks clear of the ground. FURTHER PROCESSING & INSTALLATION Compliance with standard practice, with regulations and with health and safety rules should be maintained at all times. Cutting and machining in the workshop possible except laser technology. PRODUCTION SITES Production on Thébault’s sites in France Groupe THEBAULT 47, rue des Fontenelles - 79 460 MAGNE - France Tél : +33 (0)5 49 35 70 20 [email protected] Bonding (IAW EN 314-2): class 3 Service (IAW EN 636): class 3 exterior conditions TeboPaint Garant

TECHNICAL PROPERTIES Characteristic values (MPA) IAW EN 789 - 1058 for structural calculations IAW Eurocodes 10 Available on DOP Strength in: Tension (ft), Compression (fc), Panel shear (fv) and Planar shear(fr) Modulus of elasticity in: Tension (Et), Compression (Ec), Panel shear (Gv) and planar shear (Gr) Others characteristic values Uses Use in structural applications (IAW EN 13986, EN 636-3, EN 636-2, EN 636-1) Suitable for use as structural element in exterior conditions (service class 3), humid conditions (service class 2) and interior conditions (service class 1) Guarantees conditions...

TeboPaint Garant SURFACE CHARACTERISTICS TeboPaint okoume is a semi- finished surfaced with a hot pressed white paintable melamine film. The melamine film is open to allow a good adhesion of the finishing coats. The adhesion performance of the priming coat can exclusively be evaluated in accordance with the following test method: ISO 2409 The melamine film is not a full & final finishing system but only one of its components. This characteristic confers the surface layer some brittleness and tendency to staining / marking but also ensures good adhesion of subsequent finishing layers. The final...

TeboPaint Garant Further processing and installation of TeboPaint plywood Proceed in accordance with the state of the art, the national regulations and refer to the THEBAULT Group recommendations available on our website using the following link: http://www.groupe-thebault.com/IMG/pdf/thebault_fp_gb_bardages.pdf GUIDELINES FOR APPLICATION OF FINISHING COATINGS Selection of the finish coats TeboPaint plywood can be finished with conventional oil-based and water-based paints applied by spray, brush or roller. Water based, acrylic type, finishing coats are compatible after preliminary usual tests...