LIFTPARKER N4102
8Pages

Parki Parking on 2 levels with pit rk o vels t t Liftparker N 4102 The best solution for ceiling heights below 3m

Area of application: residential buildings, hotels, ofce buildings, single garages above ground, prefabricated garages The upper platform is horizontal, the lower inclined approx. 8°. free space Load per platform max. 2000kg Load per wheel max. 500kg wall opening 10 x 10 for hydraulic and electrical lines in case of intermediate walls The shown dimensions in the drawing are standard dimensions. drainage channel 10 x 10 with collecting pit 50 x 50 x 20 column height Standard: car width max. 190cm, load per platform max. 2000kg, load per wheel max. 500kg HO* platform above: Is not suitable...

Width dimensions • Garages All dimensions are minimum dimensions. All dimensions in cm. Tolerances to the German Norm VOB part C (DIN Note: Dimensions do not include the dimensions of the hydraulic unit. Dimensions of the hydraulic unit and the switch cabinet shown in page 4 below, are to be considered in the planning. partition walls * gives clear platform width * gives clear platform width * gives clear platform width

Features in the scope of delivery Scope of supply S/D-system with 2 platforms, 2 columns, hydraulic cylinder, lifting carriage Width of parking space Width of parking space 230cm and depth of pit 1 key-switch Safety devices Key switch synchronizing device for safe operation even with Key switch incl. emergency stop, dead man´s unequal load distribution on the platform control type with brief operating instructions entering wedge for easy drive-in and parking and wiring to hydraulic unit. locking device prevents lowering by pipe breakage or leakage xation of the car parking systems and...

Extra Equipment and Options Width of parking space button lifting button lowering emergency stop Width of parking space 240cm and 250cm is recommended for even more vehicle comfort key switch with key interlock Vehicle weight Optional vehicle weight: 2500kg – not by inclined parking Berlin control system/Fire brigade spaces. We recommend to use for these vehicles our Interlocked key switch, removal of the key only solutions Liftparker N 4400 and N 4600 with horizontal in the upper basic position. accessible platforms. Additional sound insulation structure-borne noise package to comply with...

Interfaces to be performed by the Buyer Foundation Foundation works exactly to size, clean and dry is to be completed by the start of the installation. Bonded anchors for high foundation requirements shall be provided if neccessary, available also as option. Foundation plan single-system The pit must be executed in compliance with the designated forces. The forces and loads are transfered to the foundation by bearing plates with an area of 150cm². The bearing plates are xed with metal expansion anchors. The drill hole depth is approx. 14 cm. All walls in the pit below the entrance level...

Width dimensions Garages with doors single system for 2 cars TA = seat-engaging surface for doors The dimensions must be agreed with S- the door manufacturer on site. width of parking space door entrance width DB double system for 4 cars driving lane in accordance to the local requirements width of parking space door entrance width DB

Installation diagram F Figure: Car parking system with 3 inclined accessible platforms. i 7 S Specications are also apply to s systems with horizontal accessible platforms. p fuse or automatic circuit 3 x 16 amp slow to DIN VDE 0100 part 430 supply line 5 G 2,5 mm² or according to local requirements feed cable to main switch lockable main switch near to hydraulic unit foundation earth connector corner pit oor/ rear wall from foundation earth connector to the system hydraulic unit with 3-phaze motor 230/400 volt, 50 hz 3 kW supply line 5 G 2,5 mm² with marked wires and protective conductor...