PERFORMANCE EDGE™ 3 in 1 Interior Eggshell Paint GL500 DESCRIPTION ® SPECIFICATION DATA ™ ™ GLIDDEN PERFORMANCE EDGE 3 IN 1 paint simplifies the prep work of painting. It fills – filling small blemishes, small nail holes and hairline cracks, primes and paints all in one. Color: White, & custom colors Tint the appropriate base with universal colorants Finish: Eggshell Gloss - 4 - 8 units @ 60º Clean-up Solvent: Soap & water Density: 11.05 lbs/gal (1.33 kg/L) VOC: 50 g/L (0.42 lbs/gal) maximum Refer to MSDS for regulatory VOC content of complete product line FEATURES • • • • • Conceals nail holes less than 1/16”, small dings and hair line cracks. Primer built into the paint providing excellent coverage over dark colors and scuff marks. Ultra thick formula means virtually no spatter or drips. No flashing or shadowing over repaired areas. Highly scrubbable finish, even the ultra flat. COMPOSITION • • • Vinyl-Acrylic Resin Titanium Dioxide and Extender Pigments Not manufactured with lead or mercury containing materials. Solids: Volume - 42% +/- 1% Weight - 56% +/- 1% Practical Coverage: 2 Apply at 300-400 sq ft/gal (7-10 m /L). Actual coverage may vary depending on substrate and application method. Recommended Film Thickness: 4.0 - 5.3 mils wet 1.7 - 2.2 mils dry Flash Point: None Dry Time: 77°F (25°C) & 50% RH To touch - 30 - 60 minutes To recoat - 2 - 4 hours Shelf Life: 1 year minimum - unopened Read Label and Material Safety Data Sheet Prior to Use. See other cautions on last page. DSF1-0690

SURFACE PREPARATION GENERAL SURFACE PREPARATION: All surfaces must be sound, dry, clean and free of oil, grease, dirt, rust, mildew, form release agents, curing compounds, loose and flaking paint and other foreign substances. Wash walls with a detergent and water solution before painting and rinse well. Glossy surfaces must be dulled by sanding to insure proper adhesion to the underlying surface. Remove sanding dust. Remove loose paint. Fill cracks larger than hairline and nail holes larger than 1/16” with spackle. DRYWALL - Joint compound must dry for two days. Remove sanding dust. Prime new...