GRIPPER® GREY Interior/Exterior Primer & Sealer GL3250 DESCRIPTION ™ GLIDDEN GRIPPER GREY is the premium quality water-based, fast-drying primer and sealer that can be used under deep and vivid topcoats to enhance color and reduce the number of topcoats. Additionally, this product provides excellent adhesion on hard-to-stick interior and exterior surfaces including wood, masonry and previously painted surfaces. Under light color topcoats, use GLIDDEN GRIPPER WHITE primer and sealer for hardto-stick surfaces. Interior or exterior use Great for hard-to-stick surfaces Blocks stains High hiding Excellent sealing & adhesion Quick drying and recoat Easy application Moisture and alkali resistant up to 13.0 pH Low odor/Low VOC COMPOSITION • Waterborne Acrylic Resin • Titanium Dioxide and Extender Pigments • Not manufactured with lead or mercury containing materials. Color: Grey (tintable. limit up to 7 oz/gal) Clean-up Solvent: Soap and water Finish: Non-Flat Gloss: >5 units maximum @ 60º Density: 11.22 lbs/gal (1.35 kg/L) Solids: Volume - 44% +/- 1% Weight - 58% +/- 1% VOC: 100 g/L (0.84 lbs/gal) maximum Refer to MSDS for regulatory VOC content of complete product line Theoretical Coverage @ 1 mil dry: 2 704 sq ft/gal (17 m /L) Practical Coverage: Apply at 350-400 sq ft/gal (9-10 m²/L). Actual coverage may vary depending on substrate and application method. Recommended Film Thickness: 4.0 - 4.6 mils wet 1.8 - 2.0 mils dry Airless Spray Application: Pressure - 2000 psi Tip - .015” - .019” Dry Time 77°F (25°C) & 50% RH: To touch – 30 minutes To recoat – 1 hour Flame Spread Rating: Class A (0-25) on non-combustible surfaces Flash Point: None Shelf Life: 1 year minimum - unopened Read Label and Material Safety Data Sheet Prior to Use. See other cautions on last page. DSF1-0690

SURFACE PREPARATION Spackle holes or cracks • Lightly sand glossy areas. Make sure all areas are clean, sound and free of flaking paint or all substances such as oil, grease, dirt…anything that will get between your surface and your primer • Wash mildewed surfaces with a solution of 16 oz (473 mL) liquid household bleach and two oz (59 mL) non-ammoniated liquid detergent per gallon (3.785 L) of water • Rinse well with clean water • Allow to dry 24 hours • Apply GLIDDEN™ GRIPPER® primer & sealer to properly prepared previously painted surfaces. CONCRETE, PLASTER, MASONRY AND STUCCO - Cure for...