GUD24ESSM Electric Dryer - This appliance should be connected to an individual, properly-grounded branch circuit with 120/240V single-phase 60 Hz electrical service and should be protected by 30-amp time-delay fuses or circuit breakers. This appliance is manufactured with neutral connected to the frame. Power cord should be purchased separately. NOTE: These appliances are not approved for 120-volt operation. GAS REQUIREMENTS: GUD24GSSM Gas Dryer - This appliance should be connected to an individual branch circuit with a three-prong grounding-type receptacle and 120-volt singlephase 60 Hz electrical service and should be protected by 15- or 20-amp time-delay fuses or circuit breakers. This appliance is equipped with a 6-foot long flexible U.L. listed 20-amp power cord to match a 15-amp receptacle. GAS RATED input 10,500 BTU/HR. Factory equipped for natural gas. Tested for LP gas. Dryers must be exhausted to the outside. INSTALLATION INFORMATION: For complete information, see installation instructions packed with the product. 24” NOMINAL PRODUCT DIMENSIONS Vent Gas Inlet (Rear view of appliance) 2-3/4" For answers to your Monogram, GE Cafe™, GE Profile™ or GE Appliances product questions, visit our website at geappliances.com or call GE Answer Center® Service, 800.626.2000.

For complete information, see installation instructions packed with your dryer. DUCTING MATERIALS: This dryer MUST be vented with 4” diameter all rigid metal exhaust duct. EXHAUST LENGTH CALCULATION: 1. Determine the number of 90° turns needed for your installation. If you exhaust to the side or bottom of dryer, add one turn. 2. The maximum length of 4” rigid (aluminum or galvanized) duct which can be tolerated is shown in the table. For every extra 90° elbow, reduce the allowable vent system length by 10 ft. Two 45° elbows will be treated like one 90° elbow. For the side exhaust installations,...

GUD24 DRYER EXHAUST LENGTH* DIMENSIONS AND INSTALLATION INFORMATION (IN INCHES) Special Installation Requirements ALCOVE OR CLOSET INSTALLATION: - If your dryer is approved for installation in an alcove or closet, it will be stated on a label on the dryer back. - The dryer MUST be exhausted to the outside. - Minimum clearances between dryer cabinet and adjacent walls or other surfaces are: 0” both sides and rear, 1” front and top - Minimum vertical space from floor to overhead cabinets, ceilings, etc. is 75-1/2”. - Closet doors must be louvered or otherwise ventilated and must contain a minimum...

GE® Unitized Spacemaker® 2.3 DOE Cu. Ft. Stainless Steel Washer and 4.4 Cu. Ft. Dryer FEATURES AND BENEFITS Rotary-electromechanical controls (dryer) – Allow fast, easy cycle selection 11 wash cycles – Cycles are designed to specifically handle various fabrics and soils 6 wash/rinse temperatures – Select the right temperature for ideal wash results 1 wash/spin speed combinations – Speeds are matched to fabric type for great clothes care Auto-load sensing – Washer will automatically measure the load size and add just the right amount of water Rotary-electronic controls (washer) – Simplify cycle...