FONTANA LIMA ULTRA THIN RAIN SHOWER HEAD WITH BUILT IN THERMOSTATIC MIXER AND HAND HELD SHOWER SET INSTALLATION INSTRUCTIONS PRIOR TO INSTALLATION Please read installation instructions below. All plumbing should be installed in accordance with applicable building codes and regulations. Unpack and inspect the items for any shipping damages. If you find damages, do not install. All products must be installed by a professional and certified plumber otherwise warranty may be voided. POSSIBLE TOOLS REQUIRED* Plumbers Tape Tape Measure Thread Sealant Adjustable Wrench fontanashowers.com Customer Service: 800-684-44

Wall Mount Shower Installations Instructions Step 1: fontanashowers.com Customer Service: 800-684-4489

1. Apply plumber's tape to the threads on both ends of the shower arm and slide on the decorative escutcheon. 2. Insert the new arm into the fitting in the Wall and twist to tighten. Finish tightening with your adjustable wrench. Wrap a dry cloth around the shower arm to protect the finish while tightening with adjustable wrench. 3. Thread the new shower head onto the arm and hand-tighten. Hold the shower arm in place with groove joint pliers and finish tightening the shower head with your adjustable wrench. Wrap both in a dry cloth to protect the finish. 4. Before securing the decorative escutcheon,...

Ceiling Mount Shower Installations Instructions Step 1: fontanashowers.com Customer Service: 800-684-4489

Step 1: Take Out the Old Shower Head You can easily remove it by hand, but depending on how long the rain showerhead has been installed, you might need to use an adjustable wrench. Hence, if you find it difficult to remove, rotate the showerhead with an adjustable wrench in a counterclockwise direction to unscrew it. Step 2: Keep the Shower Arm Clean and In Good Shape After you have removed the head, check the shower arm threads for any debris and old Teflon tape. If you find any, remove it and clean them off thoroughly. It’s best to use a microfiber cloth when cleaning the thread because it removes...

Hand-Held Shower Installations Instructions Step 1 Hand Shower Outlet Installation • Complete the outlet pipework ensuring it ends in an appropriate 15mm x 1/2" BSP female thread elbow. Note: This fitting is not supplied as variations in installations require the selection of a suitable solder or compression fitting. • Install the 'Wall Outlet', thread long male 1/2" BSP into the appropriate female fitting using PTFE tape to give a watertight joint. Note: The thread can be cut to size if required. Make sure that all debris is removed from the connector and the section that has been cut is dressed...

Mixer Installations Instructions Step 1 fontanashowers.com Customer Service: 800-684-4489

General Information All products manufactured and supplied by Fontana are safe and comply to legislative requirements. Providing they are installed correctly and receive regular maintenance in accordance with these instructions your user experience will not be affected Care & Cleaning 1. The product can be cleaned with warm water, a mild soap and a clean soft cloth. 2. Clean progressively and gently. 3. It is not required to use any abrasive cleaning pads, wire wool or cloths to clean the product. 4. Avoid a vigorous cleaning action, as this could contribute to denaturing and dulling 5. Abrasive...