QuickSeam FormFlash
1Pages

Technical Information Sheet QuickSeam™ FormFlash FormFlash™ 1. Description Firestone QuickSeam™ FormFlash™ consists of a 152 mm (6”), 229 mm (9”), 305 mm (12”) or 450 mm (18”) uncured EPDM strip factory-laminated to QuickSeam Tape. The strip is designed to flash inside and outside corners, pipes, penetrations and other applications as specified in the Firestone specifications and details. 2. Preparation The RubberGard™ EPDM surfaces and/or mating surfaces must be prepared with Qu QuickPrime™ Plus, using a QuickScrubber™ or QuickScrubber™ Plus tool. Use of other products is not allowed. Restore the product to ™ room temperature prior to use if exposed to temperatures below 15°C for prolonged periods. xposed 15°C 3. Application On cloudy days with ambient temperature below 15°C, the use of a heat gun is recommended to warm the 15°C, QuickSeam FormFlash and to ensure good formability. On sunny days, pre pre-heating of the product is usually not necessary. QuickSeam FormFlash is to be applied as per the Firesto specifications and details. Firestone 4. Coverage In accordance with length of detail. Base Color Solvents Solids State Thickness Width EPDM Flashing EPDM Black None 100% Uncured 1.6 mm 152 mm - 229 mm - 305 mm - 450 mm QuickSeam Tape Rubber polymers Black None 100% Cured 0.6 mm 156 mm - 235 mm - 311 mm - 456 mm 6. Packaging / Storage / Shelf Life Packaging Part numbers Note: QuickScrubber and/or QuickScrubber Plus pads and handles are included in each carton. Quantities vary depending on the QuickSeam product. Shelf Life: 12 months, when stored in above mentioned conditions. Verify production date o each roll. Shelf above-mentioned on life will be reduced if exposed to higher temperatures. 7. Precautions Refer to Safety Data Sheets. Firestone Building Products Europe I Ikaroslaan 75 I 1930 Zaventem I Belgium T. +32 (0)2 711 44 50 I F. +32 (0)2 721 27 18 I info@fb @fbpe.be I www.firestonebpe.com Storage: Store in original unopened containers at temperatures between 15°C and 25°C.