Fermacell flooring
24Pages

{{requestButtons}}

Catalog excerpts

Fermacell flooring - 1

FERMACELL Dry Flooring Elements Thermal Floor

Open the catalog to page 1
Fermacell flooring - 2

FERMACELL floating floor systems For new build and renovation over masonry, suspended timber or steel constructions FERMACELL flooring systems are designed for use as floating floors in a wide variety of applications. They are manufacturerd throughout Europe by Fermacell GmbH using the same technology as the high performance FERMACELL wallboards, and are available through builders merchants in both the United Kingdom and the Republic of Ireland. For more information about the company and it’s products, or for an up to date list of stockists in your area, please visit our website at:...

Open the catalog to page 2
Fermacell flooring - 3

FERMACELL Flooring Elements can be used over the following: ■ FERMACELL dry levelling compound (100 mm max) ■ FERMACELL bonded levelling compound ■ FERMACELL self levelling compound ■ 30 mm FERMACELL honeycomb ■ 60 mm FERMACELL honeycomb ■ Expanded polystyrene foam of at least 20 kg/m3 ≤ 30 mm under the 2 E 11 and 2 E 22 flooring elements ■ Extruded polystyrene foam of at least 33 kg/m3 ≤ 100 mm under the 2 E 11 flooring elements and ≤ 120 mm under the 2 E 22 flooring elements. For improved thermal insulation Insulation from airborne and impact noise FERMACELL flooring elements offer...

Open the catalog to page 3
Fermacell flooring - 4

Ready to fit system, easy to handle, cost effective to install allowing immediate use Easy installation FERMACELL flooring elements are easy to install. Care should be taken to ensure that the floor is clean, dry and even, so that the FERMACELL flooring rests on the entire surface. The laps of the boards are glued together and the edges are screwed (or stapled). This ensures a perfect site finish every time. This system ensures high point and rolling load resistance, even over the joints. For full technical details including load capacities for FERMACELL flooring elements, please refer to...

Open the catalog to page 4
Fermacell flooring - 5

FERMACELL Flooring Elements – a system with many advantages: ■ Simple and quick installation. It takes very little time to fit. Waste is avoided by using the off-cuts to start the following row. ■ Provides a light weight solution capable of withstanding high traffic and point loads. (FERMACELL flooring elements must always be laid over a structural floor). ■ Granular dry levelling compound can be used where the structural floor is uneven. ■ No drying time, no waiting. Following trades can commence once the glue has hardened (usually 24 hours). It is possible to walk on the FERMACELL dry...

Open the catalog to page 5
Fermacell flooring - 6

FERMACELL Levelling Compounds FERMACELL produce three types of levelling compound to suit varying requirements: 1. FERMACELL Dry Levelling Compound 2. FERMACELL Bonded Levelling Compound (combined structural and thermal performance) 3. FERMACELL Self-Levelling Compound (a wet solution for the ultimate flat floor finish) FERMACELL Dry Levelling Compound FERMACELL dry levelling compound is suitable for use in new build and renovation: the special physical properties of the porous mineral granules mean they can be used for a variety of applications. This material is suitable for all floating...

Open the catalog to page 6
Fermacell flooring - 7

Easy to lay The finished floor level of the dry flooring must be set out and marked on the walls with the aid of a level or a chalk line or laser. The granules are poured out and levelled off with a straight edge as shown in the photographs above. The FERMACELL dry levelling compound must be laid to a minimum of 10 mm deep and a maximum of 100 mm. A special FERMACELL floor levelling set is available from our distributors. Alternatively, strips of graded timber or other straight materials may be used to set the height of the compound. The surface of the FERMACELL granules is then ready to...

Open the catalog to page 7
Fermacell flooring - 8

FERMACELL Bonded Levelling Compound FERMACELL bonded levelling compound is a lightweight cement and polystyrene based material suitable for filling voids from 40 mm to 2 metres. ■ A simple way to provide a structural base ready to accept FERMACELL dry flooring elements. ■ Rapidly fills deep voids whilst providing additional thermal insulation ■ Can be laid over services ■ Ready to accept foot traffic after 6 hours ■ Robust, stable, vermin-proof and impermeable to water ■ Vapour barrier not required It´s installed in the following way: Empty sack into mixing Pour onto first side of floor...

Open the catalog to page 8
Fermacell flooring - 9

Typical Applications Ground-supported concrete floor (1) 2 E 14 FERMACELL dry flooring element with 30 mm rigid foamed polystyrene (2) FERMACELL levelling compound (to level up an uneven sub-floor and provide additional thermal insulation) (3) Vapour control layer (4) Concrete floor (5) Perimeter strip to isolate floor construction from walls Suspended timber floor with uneven floorboards (1) (1) 2 E31 FERMACELl dry flooring element with 10 mm wood fibre (2) FERMACELL levelling compound (to level up an uneven sub-floor and improve impact sound performance) (3) Trickle-proof barrier layer...

Open the catalog to page 9
Fermacell flooring - 10

FERMACELL Honeycomb Acoustic System High performance acoustic insulation with FERMACELL Honeycomb System The FERMACELL honeycomb system is suitable for both renovation work and new build. FERMACELL honeycomb is used as a modern version of acoustic pugging – i.e. it adds mass to lightweight (typically) timber floor constructions. Unlike traditional forms of pugging, the honeycomb is laid over the existing structural floor, thus avoiding the need to take up floorboards during installation. The 30 mm or 60 mm thick FERMACELL honeycomb board is laid over the whole area of the floor and is...

Open the catalog to page 10
Fermacell flooring - 11

A Dry Solution For Underfloor Heating Systems Typical Basic System (1) (2) Ideal for under-floor heating For under-floor heating systems using warm water, the 25 mm 2 E 22 or 20 mm 2 E 11 FERMACELL (only for specific systems) flooring elements – developed especially for this purpose – are the ideal solution; providing the fast response times not possible with concrete screeds, with the rapid installation of a dry flooring system. Detailed information is available in the document ”FERMACELL Dry Flooring Elements – Instruction Manual”. (1) FERMACELL dry flooring element 2 E 22 or 2 E 11...

Open the catalog to page 11

All Fermacell GmbH catalogs and technical brochures

  1. the orange book

    126 Pages

  2. partitions

    22 Pages

  3. Linings

    5 Pages

  4. wet area

    8 Pages

  5. intoduction

    24 Pages

Archived catalogs

  1. Rainscreen

    4 Pages

  2. Timber Frame

    4 Pages

  3. Linings

    14 Pages