Grab Bar 12.4030
2Pages

FC Frost Limited Bankside Works Benfield Way Braintree Essex CM7 3YS United Kingdom T: +44 (0)1376 329111 F: +44 (0)1376 347002 E: sales@fcfrost.com W: www.fcfrost.com Specification FC Frost Ltd model number 12.4030 Fold down grab bar 800mm long in satin finish stainless steel with soft fall mechanism. Material  Grab Bar: Ø32mm x 1.5mm tube satin finish stainless steel grade 1.4301 (304) Operation To lower trombone bar when in vertical position; lift bar vertically removing the bar from its seating and lower bar to horizontal position. To relocate bar perform the above operation in reverse. Assembly: Kit: 1 x Grab bar 1 x back plate 1 x Assembled Bolt with 2 x Dome head nuts and 2x Spring washers. 6 x screws and wall plugs (Screws required for application may differ to that supplied)     Locate stud/saddle washer/dome nut assembly in fixing kit and dismantle. Fit grab bar arm with black saddle washers and stud to back plate. Fit spring washers and dome nuts to end of stud. Tighten dome nuts until desired level of grip is achieved. A soft fall motion should be achieved. Recommended mounting height from top surface of rail (when in drop down position) to FFL 680mm Mark location of fixing holes on wall. Drill holes and fix wall plate (fit rubber cushion between plate and wall if desired) to wall using suitable screws. It is imperative that suitable fixings for the wall installation are used (Screws required may differ to that supplied) FC Frost Ltd reserves the right to amend the design or dimensions without formal notice. © FC

FC Frost Limited Bankside Works Benfield Way Braintree Essex CM7 3YS United Kingdom T: +44 (0)1376 329111 F: +44 (0)1376 347002 E: sales@fcfrost.com W: www.fcfrost.com Care and Maintenance Clean with soap and warm water, dry with a clean soft cloth. To maintain finish use any industrial steel cleaner, polishing along the material grain with a clean soft cloth. FC Frost Ltd recommends “Steel Clean” cleaning agent, obtainable from: Vitopan (Tel: 01204 863000) Abrasive cleaners, chloride cleaning agents and carbon steel brushes/steel wool will scratch the stainless steel and should not be...