Curved Back Rest
2Pages

FC Frost Limited Bankside Works Benfield Way Braintree Essex CM7 3YS United Kingdom T: +44 (0)1376 329111 F: +44 (0)1376 347002 E: sales@fcfrost.com W: www.fcfrost.com Back Rest 12.2145! v. Specification FC Frost Ltd Back Rest. Model number 12.2145 in satin finish stainless steel with white PVC pad. Material • Bar: 032mm x 1.5mm tube satin finish stainless steel grade 1.4301 (304) • Cover Plates: 0.5mm satin finish stainless steel grade 1.4301 (304) • Wall Mounts: 3mm stainless steel grade 1.4301 (304) • Pad: PVC covered foam with hard board backing (Supplied with fixings) • Approximate unit weight: 1.6kg • Tested to 120kg BS EN 12182:1999. Achievable weight load dependent on wall construction/fixings. Installation • Recommended mounting height from top surface of bar to FFL 680mm - Horizontal mounting • Unclip covers from wall mounts and slide covers away from mounts • Mark location of fixing holes on wall. • Drill holes and fix rail to wall using suitable screws (Support holes size 07mm). It is imperative that suitable fixings for the wall installation are used • Slide covers back down leg on to wall mount • Clip covers on to wall mounts Fixing the pad • Place mounting clip over back rest bar and offer pad up to it • Place supplied screws through clip and tighten screws into the inserts located in the rear of the back pad. • Repeat process for both clips. Ensure pad is centralised on bar. FC Frost Ltd reserves the right to amend the design or dimensions without formal notice. © FC Frost Ltd

FC Frost Limited Bankside Works Benfield Way Braintree Essex CM7 3YS United Kingdom T: +44 (0)1376 329111 F: +44 (0)1376 347002 E: sales@fcfrost.com W: www.fcfrost.com Care and Maintenance Clean with soap and warm water, dry with a clean soft cloth. To maintain finish use any industrial steel cleaner, polishing along the material grain with a clean soft cloth. FC Frost Ltd recommends “Steel Clean” cleaning agent, obtainable from: Vitopan (Tel: 01204 863000) Abrasive cleaners, chloride cleaning agents and carbon steel brushes/steel wool will scratch the stainless steel and should not be...