1. Catalogs
  2. Fassa Bortolo
  3. Restoration Line EX NOVO
video corpo

Restoration Line EX NOVO

Restoration Line EX NOVO
1 / 20 PagesView full catalog

Restoration Line EX NOVO

Product catalog summary
Introduction
The document focuses on the EX NOVO Restoration Line, emphasizing the use of natural hydraulic lime (NHL) for building restoration. It highlights the importance of using materials compatible with historical architecture while adhering to modern environmental standards.
Historical Context
Lime has been used in construction since ancient times by civilizations such as the Phoenicians, Greeks, and Romans. These cultures valued lime-based mortars for their durability and water-setting capabilities, a technique refined over centuries.
Natural Hydraulic Lime (NHL)
NHL is produced by burning limestone with clay and silica. It is categorized by compressive strength: NHL 2, NHL 3.5, and NHL 5. NHL is favored for its environmental compatibility and historical authenticity.
Research and Development
The Fassa Bortolo Research Centre developed the EX NOVO line, focusing on NHL and crushed terracotta for restoration projects, aiming to preserve historical structures while ensuring environmental sustainability.
Case Study: San Bernardino Church
The restoration of the San Bernardino Church used EX NOVO products to address rising damp and preserve the Baroque facade, involving repointing joints, applying salt-resistant undercoats, and using specific plasters and finishes.
Product Range
The EX NOVO line includes products like bio masonry mortars, undercoats, and finishes made from NHL 3.5, designed for various applications, including damp masonry restoration.
Technical Specifications
Products such as MALTA DI ALLETTAMENTO 770 and MALTA FACCIA A VISTA 767 are detailed with specifications on composition, usage, and storage, emphasizing consistent quality and environmental standards.
Product Details
RINZAFFO 720: An undercoat enhancing adhesion in damp conditions, with warnings against freezing and rapid drying. It has a compressive strength of 11 N/mm² after 28 days.
INTONACO 700: A base coat plaster for brick or stone walls, with similar precautions as RINZAFFO 720, and a compressive strength of 2.5 N/mm² after 28 days.
INTONACO MACROPOROSO 717: Designed for damp masonry restoration, requiring a minimum thickness of 3-4 cm, with a compressive strength of 2.5 N/mm² after 28 days.
FINITURA IDROFUGATA 756: A water-repellent finish applied over base coat plasters, with a compressive strength of 2.5 N/mm² after 28 days.
General Recommendations
All products should be stored in a dry place and used within their specified shelf life. Proper surface preparation and adherence to application guidelines are crucial for optimal performance.
Technical Specifications Overview
1. Finitura Idrofugata 756: Water repellent, sulphate resistant, made from NHL 3.5 and graded sand, suitable for exteriors and interiors.
2. Finitura 750: Finish coat plaster for damp masonry restoration, requiring high breathability.
3. Legante Per Iniezioni 790: Injection grout for reinforcing foundations and walls in historic buildings.
4. Intonaco di Cocciopesto 738: Base coat plaster for interiors and exteriors, made from NHL 3.5, crushed terracotta, and graded lime sand.
5. Intonaco di Cocciopesto Macroporoso 740: Base coat plaster for restoring damp masonry, applied by hand or machine.
Technical Specifications:
INTONACO DI COCCIOPESTO MACROPOROSO 740 is a dry, water-repellent mortar made from NHL 3.5, crushed terracotta, and graded lime sand, designed for damp masonry restoration.
Physical Properties:
  • Density: Approx. 1,350 kg/m³
  • Flexural Strength: Approx. 1 N/mm²
  • Compressive Strength: Approx. 2.5 N/mm²
  • Modulus of Elasticity: Approx. 4,000 N/mm²
  • Water Vapour Diffusion Resistance Factor: µ = 8
  • Water Absorption Coefficient: 0.3 kg/m² after 24 hours
  • Water Penetration: 5 mm
  • Thermal Conductivity: λ = 0.45 W/m·°K
  • Air Incorporated: Approx. 25%
  • Radioactivity Index: I = 0.35 ± 0.05
  • Radon Exhalation Rate: Iα = 0.40 ± 0.05
Compliance:
Conforms to EN 998-1 R-CSII and EN 459-1 standards.
Application Guidelines:
  • Surfaces must be clean and free from salt efflorescence.
  • Old plaster should be removed to at least one meter above visible dampness.
  • Apply on surfaces treated with an undercoat like FASSA RINZAFFO 720.
  • Minimum application thickness is 2 cm.
  • Consumption: Approx. 11.5 kg/m² per cm in thickness.
Supply and Storage:
  • Available in special sacks of approx. 30 kg.
  • Store in a dry place for up to 6 months.
Quality Assurance:
The product undergoes continuous quality checks, and raw materials are carefully selected and tested.
Contact Information:
FASSA S.p.A., Via Lazzaris, 3 - 31027 Spresiano (TV) - Italy. Tel: +39 0422 7222, Fax: +39 0422 887509, Website: www.fassabortolo.com, Email: [email protected]
See more

Catalog excerpts

Restoration Line EX NOVO-1

Restoration Line EX NOVO

 Open the catalog to page 1
Restoration Line EX NOVO-2

The stones we take from rivers and streams, the cobblestones or pebbles, make excellent lime, giving a very white and clean effect, above all when used for plastering walls. Andrea Palladio

 Open the catalog to page 2
Restoration Line EX NOVO-3

EX NOVO Restoration Line - Presentation esearch into the preservation of old buildings is today focused on new materials for renovation and restoration. New materials whose roots however lie in the history of architecture, making them compatible both with the materials and techniques used on the existing buildings and the modern need for environmental compatibility and protection. In the past, the quality of plaster was a fundamental element in the life of the building. The care paid to selecting raw materials, preparing mixes and applying materials was concentrated on optimising both the quality of...

 Open the catalog to page 3
Restoration Line EX NOVO-4

EX NOVO Restoration Line Natural hydraulic lime and its history Anonymous engraving in “Dizionario delle Arti e dei Mestieri”, F. Griselini, Venice 1768-78, 18 vol. “The discovery of a binder that can set and harden in an aqueous environment dates back to the Phoenicians. (…) The Phoenicians are believed to have prepared mortar made from air hardening lime and volcanic sand coming from the Cyclades. Water cisterns, plastered with hydraulic mortar, have been found in Jerusalem, dating back to the kingdom of Solomon (10th century BC) and believed to have been built by Phoenician workers. The ancient...

 Open the catalog to page 4
Restoration Line EX NOVO-5

The Romans were nonetheless able to obtain hydraulic mortar by adding pozzolana to the mix. Like the Greeks and the Phoenicians before them, they too realised that some volcanic deposits, when ground and mixed with sand and air hardening lime, produced a mortar that not only had higher mechanical strength than those obtained using lime only, but also the property to resist the action of both fresh and salt water.” P. Accinelli - La storia della calce. - 2008 Engraving by A. Carracci in A. Carracci “Arti, Mestieri e figure tipiche”, table 65, Rome 1646. “Lime or calcium oxide, from the Latin calx...

 Open the catalog to page 5
Restoration Line EX NOVO-6

EX NOVO Restoration Line The responses to modern renovation and restoration requirements first see the light at the Fassa Bortolo Research Centre, to be then applied in the field, in that vast outdoor laboratory that is Venice, a city where all renovation and restoration work has to be perfect. To ensure best results, Fassa Bortolo has completed in-depth analysis on the properties, doses and application of 'ancient' materials such as hydraulic lime and crushed terracotta, so as to identify products that can be used to preserve existing surfaces and build new ones, Natural hydraulic lime (NHL)...

 Open the catalog to page 6
Restoration Line EX NOVO-7

back to 1710, and the modern need for environmental compatibility. It’s no coincidence that the Bio-Architecture Line has, since 1996, been an important part of the vast range of Fassa Bortolo building products, with innovative and certified solutions for sustainable building, from masonry mortar to undercoats, from plaster to finishes. Tests at the Fassa Bortolo laboratory Care to quality that today is seen in the new EX NOVO Restoration Line, a complete range of products made from NHL 3.5 natural hydraulic lime and crushed terracotta, products designed specifically for the restoration of damp...

 Open the catalog to page 7
Restoration Line EX NOVO-8

EX NOVO Restoration Line Before the work These photographs show the conservation-restoration work performed on the main facade of the San Bernardino Church located in the old town centre of S. Stefano Roero (Cuneo province). The architectural work, dating back to the 18th century, stands out for the splendid Baroque facade and the interiors adorned with very good quality frescoes and stuccos. The renovation work, approved and supervised by the Piedmont region architectural and landscape heritage protection agency, involved carefully removing the layers of finish and plaster in the areas damaged...

 Open the catalog to page 8
Restoration Line EX NOVO-9

PRODUCT RANGE BIO MASONRY MORTAR MALTA DI ALLETTAMENTO 770 Bio masonry mortar, sulphate resistant, made from NHL 3.5 natural hydraulic lime. BIO UNDERCOAT RINZAFFO 720 Bio undercoat, sulphate resistant, made from NHL 3.5 natural hydraulic lime. MALTA FACCIA A VISTA 767 Bio mortar for facing brick walls, sulphate resistant, made from NHL 3.5 natural hydraulic lime. BIO MORTAR FOR CONSOLIDATION LEGANTE PER INIEZIONI 790 Bio mortar for consolidation, sulphate resistant, made from NHL 3.5 natural hydraulic lime. BIO BASE COAT PLASTER INTONACO 700 Bio base coat plaster made from NHL 3.5 natural hydraulic...

 Open the catalog to page 9
Restoration Line EX NOVO-10

Bio masonry mortar made from NHL 3.5 natural hydraulic lime for interiors and exteriors COMPOSITION MALTA DI ALLETTAMENTO 770 is a dry, sulphate resistant mortar, made from NHL 3.5 natural hydraulic lime and graded lime sand. SUPPLY • Special sacks with protection against moisture, approx. 30 kg. STORAGE Store in a dry place for a maximum of 12 months. QUALITY MALTA DI ALLETTAMENTO 770 undergoes accurate and continuous checks in our laboratories. The raw materials used are carefully selected and checked against the reference standards. CONTRACT SPECIFICATIONS Bedding mortar for raised interior...

 Open the catalog to page 10
Restoration Line EX NOVO-11

I MALTA FACCIA A VISTA 767 Water repellent bio mortar for facing brick walls made from NHL 3.5 natural hydraulic lime for interiors and exteriors COMPOSITION MALTA FACCIA A VISTA 767 is a dry, water repellent, sulphate resistant mortar made from NHL 3.5 natural hydraulic lime and graded lime sand. SUPPLY • Special sacks with protection against moisture, approx. 30 kg. STORAGE Store in a dry place for a maximum of 6 months. QUALITY MALTA FACCIA A VISTA 767 undergoes accurate and continuous checks in our laboratories. The raw materials used are carefully selected and checked against the reference standards. CONTRACT SPECIFICATIONS Bedding...

 Open the catalog to page 11
Restoration Line EX NOVO-12

COMPOSITION RINZAFFO 720 is a dry, sulphate resistant mortar, made from NHL 3.5 natural hydraulic lime and graded lime sand. SUPPLY • Special sacks with protection against moisture, approx. 30 kg. STORAGE Store in a dry place for a maximum of 12 months. QUALITY RINZAFFO 720 undergoes accurate and continuous checks in our laboratories. The raw materials used are carefully selected and checked against the reference standards. CONTRACT SPECIFICATIONS The surfaces being treated must be clean and free from salt efflorescence. Any existing old plaster must be totally removed to at least one metre above...

 Open the catalog to page 12
*Prices are pre-tax. They exclude delivery charges and customs duties and do not include additional charges for installation or activation options. Prices are indicative only and may vary by country, with changes to the cost of raw materials and exchange rates.