FAAC S.p.A. Via Benini,1 • 40069 Zola Predosa, Bologna S 051-61724 S 051-758518 B www.faacgroup.com 868 SLH SYSTEM The 868 SLH Series is a patented 868 Mhz radio-control system with encrypted self-learning Rolling Code. At every transmission, the transmitter code changes according to a complex algorithm, synchronised with data awaited by the receiver. TECHNICAL SPECIFICATIONS * External factors such as atmospheric disturbances, within-range obstacles, and charge level of transmitter batteries, can affect nominal capacity (significantly in some cases). 868 SLH TRANSMITTERS The transmitters (2/4 channel) can be of two types: master and slave. How to recognise a master/slave transmitter •master: if you press any key of a master TX, the LED flashes before becoming steady •slave : if you press any key of a slave TX, the LED goes on immediately with steady light. Differences between master and slave TX •master: only a master TX can transfer its "system code" to decoding cards/RP receivers and to other TXs (master or slave). •slave: unable to transfer its "system code" and, therefore, cannot be either duplicated, or used for coding systems. Can learn the "system code" from a master TX.

a radio receiver for connection to one or more decoding cards (one decoding card for each channel). •RP 868 SLH: single-channel radio receiver with built-in decoding facility, and rapid connector for connection to FAAC equipment. Stores up to 250 TXs. 868 DECODING CARDS •SLH Minidec: decoding card with open-collector output and rapid connector for connection to FAAC equipment. Stores up to 250 TXs. •SLH Decoder: decoding card with relay output and rapid connector to connection to FAAC equipment, plus terminal board for wired connection. Stores up to 1000 TXs. OPERATION DESCRIPTION The 868 SLH...

• On the master TX (while its LED is flashing), press and hold down the same channel used for coding the system: the LED goes on with steady light; • Press the required channel on the TX to be coded and release it when the LED goes off after flashing twice to confirm the “system code” was saved; • Release the button of the Master TX channel; • Repeat this procedure for every TX to be coded. CONVERTING A TX FROM MASTER TO SLAVE Procedure for converting a master transmitter into a slave transmitter: • Simultaneously press push-buttons P1 and P2 of the master TX and release them when the LED flashes...