Catalogs >
Exitile >
MT SB

MT SB
1 / 1Pages

Catalog excerpts

Designed to fit into any type of ceiling system allowing easy access into the cavity/void where regular maintenance to services is required to be carried out. Fire Rating Frame screw bracing channel Structural opening size = Access Panel size +7mm Hinge pin block within 25mm wide beaded frame Metal door tray Plastic dome plug &collar This panel is designed to fit into the structural membrane of jointless plasterboard ceiling systems. It is supplied with a beaded frame to allow for tape and jointing on site and comes complete with a fully removable flush metal door. It is inserted directly into a pre-cut hole through the face of the ceiling prior to wet finishes being applied. Constructed from 1.2mm and 1mm thick Zintec Steel, with a polyester powder coating of matt white Ral 9010, 20% Gloss (other colours available upon request). The panels are also available in Stainless Steel for use in corrosive areas (quote using product code and ref SS). The removable door trays are fitted with a sliding pin hinge and standard budget Standard stock sizes are available as shown below. Non-standard sizes can be manufactured to order within maximum and minimum dimensional constraints. For further information please contact our Technical Sales Department. Sizes shown are overall dimension to inside edge of frame: 300 x 300mm 450 x 450mm 600 x 600mm 900 x 600mm (hinged on long side) 1200 x 600mm (hinged on long side) The access panel should be screw fixed through the side of the panel frame, and will require independent bracing and support which is sufficient to secure and also allow safe opening of the access panel within the ceiling system. When installing the access panel, the actual size of structural opening in the ceiling needs to be +5mm greater than the overall panel dimension e.g. structural opening for 600 x 600mm will be 605 x 605mm. E-mail: sales@exitile.com

Open the catalog to page 1