*myarchiexpo

Catalogs
EUROPERFIL, SA
EUROBAC150 FS

EUROBAC150 FS

Product catalog summary

Scope: The document outlines specifications for a self-supporting cassette (tray) used in wall cladding, applicable for both horizontal and vertical installations. The material used is metallic coated steel sheet, with optional organic coatings.

Material Specifications: The steel thickness ranges from 0.70 mm to 1.20 mm, with corresponding weights and structural properties detailed. Standards referenced include EN 10143 for dimensional tolerance, EN 10346 for steel, and EN 10169 for organic coating.

Geometrical Characteristics: Key dimensions include a profile depth of 150 mm, stiffener depth of 7 mm, and a cover width of 600 mm. Tolerances for various dimensions are specified, including deviations from straightness and squareness.

Installation Guide: The document provides guidelines for installation on different bearing materials such as metallic steel, concrete, and wood. It specifies minimum bearing thickness, support bearing face dimensions, and fastener distances. Fasteners must be placed at least in three points per support, with specific requirements based on wind load and support characteristics.

Load Tables: The document includes tables for positive and negative loads, detailing the maximum allowable loads for different steel thicknesses and spans, with a deflection limitation of L/200.

Additional Information: For further clarification, contact details for the Technical Department are provided. The document notes that EUROPERFIL, S.A. reserves the right to make changes without notice.

Catalog excerpts

Wall Cladding Profile (1.600.150) SCOPE Self-supporting cassette (tray) for wall cladding as an inner surface (horizontally or vertically laid) made from metallic coated steel sheet with or without additional organic coatings. MATERIAL (Steel) Fasteners at supports: Each cassette (tray) must be fixed, at least, in three points per support. The number of screws depends on the negative wind load, the support and its thickness and the screw type. Longitudinal joint connector: The screws (diameter 4.8 mm) must be located at the rib height (1 screw per meter maximum). They can be replaced by screws for Z or omega profile, or for cladding profile. Avda. de la Granvfa, 1 79 • 08908 L'Hospitalet de Llobregat • BARCELONA • SPAIN • ®: +34 93 261 63 33 ifi: +34 93 261 63 38 Avda. Vall d'Aran, s/n • Pol. Ind. de Cervera • 25200 Cervera • LLEIDA • SPAIN [email protected] www.europerfil.com

Open the catalog to page 1

Wall Cladding Profile (1.600.150) LOAD TABLES fdaN/m21 - Limitation of deflection: L/200 For any further clarification, you can contact Technical Department [email protected] or by phone). EUROPERFIL, S.A. reserves the right to change this document without notice. Revision date: 05/12/20147 Avda. de la Granv'a, 179 • 08908 L'Hospitalet de Llobregat • BARCELONA • SPAIN Avda. Vall d'Aran, s/n • Pol. Ind. de Cervera • 25200 Cervera • LLEIDA • SPAIN [email protected] www.europerfil.com

Open the catalog to page 2

EUROBAC150 FS

EUROBAC150 FS

Catalog excerpts

All EUROPERFIL, SA catalogs and technical brochures