ELECTRIC CONVECTION OVENS
18Pages

ELECTRIC CONVECTION OVENS 4 trays to 10 trays SPEC SHEET : FFVE-EH00007-GB Pictures are not contractual. The company reserves the right to change specifications without notice - Copying forbidden

APPLIANCE CHARACTERISTICS The oven is made of A stainless steel sheet assembly forming the tighten chamber A glass door : Manual closure Electro-magnet closure (option) An external stainless steel shell A stainless steel front face black (option) red (option) white (option) Stainless steel A control board E-Drive : Touchscreen regulator (option) Control of the following functions (According to the oven equipement) : Steam (option) Exhaust vent (damper) Hood Energy saving Smells absorber Speed drive control (option) Dual-power control (option)...

INSTALLATION This is a professional equipment which must be installed into a work premises environment FORBIDDEN TO THE PUBLIC for safety reasons rules. BEFORE THE INSTALLATION, MAKE SURE THAT : The equipment must be set up on a flat floor, with a sufficient safety allowable load. The oven will be installed on a FIREPROOF SUPPORT (IMPERATIVE) : wood, etc. ... BANNED for obvious safety reasons. The oven shouldn’t be in touch with any wall. Keep at least: Control board side : 10 mm to avoid condensation problems Hinges side : 60 mm for door opening The room lay-out and the...

WATER QUALITY Although if clean and safe for consumption, the water supplied can have a bad taste (caused by the chlorine), be corrosive or cause calcareous deposits. After analysis, when the water characteristics reach critical levels, it is imperative to install a water treatment system upstream to increase the life duration of your equipment. Depending on the concentrations of chloride, carbonate and the pH value, it may also be necessary to treat water to reduce the corrosion risks A system of water treatment is strongly recommended in the following cases : if the water hardness is...

© Electrical connection through junction box at 1 m of the coupling point © If steam option - Cold water connection at 1 m of the coupling point :0 3/4”-3 bars mini - 5 bars maxi © Steam exhaust pipe (Look at the paragraph «REAR VIEW / CONNECTIONS PRINCIPLE))}: ■/ Without extractor hood or with decorative hood : Oven outlet : tube 0 76 mm ■/ With extractor hood : Hood outlet : tube 0 153 mm x Sound power : from 58 dB(A) (Low speed hood} to 71 dB(A) (High speed hood} x Air flow : from 400 m1 2 3/h (Low speed hood) to 1000 m3/h (High speed hood) @ Purging at 1 m of the coupling point 0 20 mm...

POSSIBLE CONFIGURATIONS All following configurations are represented on casters. In the case of an appliance on feet, the feet height is adjustable from 90mm to 130mm. ELECTRIC CONVECTION OVEN - 4 TRAYS 1 oven on table with or without hood oven on proofer cabinet with or without hood

2 ovens on proofer cabinet with or without hood FVE-CE en Anglais

✓ 1 oven on table with or without hood oven on proofer cabinet with or without hood

✓ 2 ovens on table with or without hood

ovens on proofer cabinet with or without hood

✓ 1 oven on table with or without hood x Table height : 550mm

oven on proofer cabinet with or without hood

ELECTRIC CONVECTION OVEN - 4 TRAYS + 10 TRAYS ELECTRIC CONVECTION OVEN - 5 TRAYS + 10 TRAYS

REAR VIEW / CONNECTIONS PRINCIPLE Depending on the oven size and door hinges position, the location of the various elements shown below may change but the connection principle remains the same. The oven must be aerated in an ambient atmosphere below 32°C (90°F), to ensure its proper operating. DO NOT OBSTRUCT THE OVEN VENTILATION GRIDS. With hood Steam exhaust pipe 1 m mini - Ø 153mm Not supplied with the hood Seal with high temperature silicone and then cover with aluminium scotch. Not supplied with the oven Check the spare parts list Stainless steel elbow fitting F-F - Ø 153mm Not...

1 or 2 ovens with hood At customer’s charge and responsibility. To be installed by a professional chimney installer. It is forbidden : to connect the steam exhaust pipe to a chimney dedicated to the fumes. to reach the outside with an horizontal pipe. To optimize the draft of the steam exhaust chimney, you must install it as straight and vertical as possible. Manufacturer’s recommendation : connect vertically a stainless steel tube with a minimum length of 1 m of Ø 153mm Not supplied with the hood Stainless steel elbow fitting Ø 153mm F-F - Not supplied with the hood Stainless steel...

Depending on the oven size and door hinges position, the location of the various elements shown below may change but the connection principle remains the same. The oven must be aerated in an ambient atmosphere below 32°C (90°F), to ensure its proper operating. DO NOT OBSTRUCT THE OVEN VENTILATION GRIDS. Without extractor hood or with decorative hood Decorative hood without extractor Seal with high temperature silicone and then cover with aluminium scotch. Not supplied with the oven Steam exhaust pipe 1 m mini Not supplied with the oven Check the spare parts list Reinforced flexible for...

1 or 2 ovens without hood At customer’s charge and responsibility. To be installed by a professional chimney installer. It is forbidden : to connect the steam exhaust pipe to a chimney dedicated to the fumes. to reach the outside with an horizontal pipe. To optimize the draft of the steam exhaust chimney, you must install it as straight and vertical as possible. Manufacturer’s recommendation : connect vertically a stainless steel tube with a minimum length of 1 m of Ø 86 mm. Not supplied with the oven Steam system outlet Ø 76 mm Steam system outlet Ø 76 mm Stainless steel tee -...