Direct Vent Gas Fireplace Information Sheet for Builders and Architects Creating the Cavity: The dimensioned drawing below shows the minimum size of cavity that must be created. Normal dry wall (Gib Board) is suitable for facing wall surfaces. Flueing: Flueing consists of 5” x 8” Simpson Duravent Direct Vent Pro system, available from Escea. For full details relating to flueing design options please consult the Installation Manual, available from www.escea.co.nz Fascia Options: Stainless Steel, or Powder Coated (Satin Black, Suede Cream, Antique Steel, Florentine Bronze) Fuel Bed Options: White coals, black coals, or driftwood log set with pebbles (pictured). Gas Specifications: Heat Output = 3.2 – 4.2kW Depending on flue configuration Gas Input = 20Mj/hr (on HIGH flame setting) Gas Connection = Front LH bottom corner of heater, 3/8” flare Gas = NG / LPG Operating Pressure = 1kPa NG / 2.3kPa LPG Inlet Gas Pressure = 1.2kPa to 5kPa NG; 2.5kPa to 5.0kPa LPG Power Requirement: To use the mains power supply as the primary power source, a standard 3-pin, earthed, 240V outlet must be within 1.5m of the lower left hand side of the appliance. The ST900 may also be run on 3 D cell Batteries as the primary or backup power source. (Available as an accessory) Product Dimensions: (mm) Minimum Cavity size: W 910 Top of cavity MUST be open to the ceiling space. Manufactured By: Escea Ltd, PO Box 5277 Dunedin, New Zealand. Phone: +64 0347