Catalogs >
Escea >
ST500

ST500
1Pages

Catalog excerpts

ST500 Direct Vent Gas Fireplace » Information Sheet for Builders and Architects Gas Specifications: Heat Output Gas Input Gas Connection Gas Type Operating Pressure Inlet Gas Pressure = 2.3 – 3.0kW Depending on flue config = 14Mj/hr on HIGH = Lower back left of fire, 3/8” flare = NG / LPG = 1kPa NG / 2.3kPa LPG = 1.2kPa to 5kPa NG = 2.5kPa to 5kPa LPG Fascia Options: Stainless Steel (pictured), Powder Coated (Satin Black, Suede Cream, Antique Steel, Florentine Bronze) Fuel Bed Options: White coals (pictured), Black coals, driftwood log set with pebbles. Flueing: Flueing consists of 5” x 8” Simpson Duravent Direct Vent Pro system, available from Escea. For full details relating to flueing design options please consult the Installation Manual, available from www.escea.co.nz Power Requirement: To use the mains power supply as the primary power source, a standard 3-pin, earthed, 240V outlet must be within 1.5m of the lower left hand side of the appliance The ST500 may also be run on 3 D cell batteries as the primary or backup power source. (Available as an accessory) Creating the Cavity: The dimensioned drawing below shows the minimum size of cavity that must be created. Normal dry wall (Gib Board) is suitable for facing wall surfaces. Minimum Cavity Dimensions: (mm) W H D ST500 510 820 370 Escea's policy is one of continuous improvement and we reserve the right to change specifications contained within this documen

Open the catalog to page 1

ST500
1Pages

Catalog excerpts

All Escea catalogs and technical brochures

Archived catalogs

ST500 1Pages

Catalog excerpts

All Escea catalogs and technical brochures

Archived catalogs

ST500
1Pages