Catalogs >
Escea >
EF5000

EF5000
2Pages

Catalog excerpts

Information Sheet for Builders and Architects Minimum Cavity Dimensions A For further information or specifications, visit the technical section of our website www.escea.com to view the latest product Installation Manual. Appliance Information Specifications Heat Output 11-14 kW Gas Input/Consumption 40-49 MJ/hr Gas Connection lower right, 1/2” BSP female thread Gas Type Natural Gas / ULPG / Propane (Aus) Weight 45 kg Power Requirement 24V AC 1A. 230/240V to 24V AC 1A transformer is supplied with the product. 24V lead length: 10m Wall cladding around the fire: The temperature of the wall directly above the heater does get hot and hence may discolour paint finishes. Some dark coloured exhaust stains may also become visible directly above the fire due to exhaust. In most cases this can be cleaned off with water and a brush. Product Dimensions Minimum install height: The fire has ventilation gaps behind the fascia at the top and bottom. These must not be blocked, so ensure there is a gap of at least 30mm between the bottom of the fascia and anything below. 630347_0 EF5000 Builders and Architects Sheet

Open the catalog to page 1

Installation Information Corner Installations: This appliance shall only be used in an above ground open-air situation with natural ventilation, without stagnant areas, where gas leakage and products of combustion are rapidly dispersed by wind and natural convection. Certain materials or items, when placed under or near the appliance, will be subjected to radiant heat and could become damaged. The following installation diagrams are escea recommendations only and may or may not comply with your local council standards. Please check with your local council for actual building standards....

Open the catalog to page 2