Information Sheet for Builders and Architects For further information or specifications, visit the technical section of our website www.escea.com to view the latest product Installation Manual. Appliance Information Gas Specifications Heat Output 10kW* Gas Input / Consumption 40MJ/hr* Gas Connection Lower right side of appliance, 1/2” BSP Gas Type Natural Gas / LPG (NZ) / Propane (Aus) Operating Pressure 0.84kPa NG / 2.2kPa LPG or Propane Inlet Gas Pressure 1.2kPa to 5.0kPa NG 2.5kPa to 5.0kPa LPG or Propane Power Requirement 3 pin earthed 230V power outlet to be within 1.0m of right side of the appliance 70 * Internal results pending confirmation from test laboratory Cavity Information Minimum Cavity Dimensions (mm): The appliance must be installed prior to and behind the finished wall surface. Take into account any plaster board, tiles or any other finishing surface that may be intended for the finished wall surface. Wall finishing materials must not encroach upon the minimum cavity clearances shown. The wall board that lines the outside of the opening can be normal plaster board and does not need to be noncombustible. Single Sided Double Sided ‘Hutch’ style cavity minimum dimensions (mm) Front Wall opening size for frameless / no fascia (mm) 630210_2

Flue and Duct Information Ducting information: This gas fire features a small network of ducting situated either in the ceiling or under the floor to distribute the heat generated by this fireplace. The maximum configurations for this ducting network are shown below and the diameters in mm. Warm room air ducted to outlets Flue information: There are two basic types of flue configuration, using a vertical powerflue cowl, or a horizontal powerflue cowl. The horizontal offset of the terminal can be any amount up to the total flue length shown. You cannot flue down, ie allow the terminal to be lower...