DL850
2Pages

Information Sheet for Builders and Architects For further information or specifications, visit the technical section of our website www.escea.com to view the latest product Installation Manual. Appliance Information Product Dimensions Gas Specifications Heat Output 9.2kW* Gas Input / Consumption 38MJ/hr* Gas Connection Rear right or front right, 1/2” BSP female thread Gas Type Natural Gas / LPG (NZ) / Propane (Aus) Operating Pressure 1.0kPa NG / 2.3kPa LPG or Propane Inlet Gas Pressure 1.2kPa to 5.0kPa NG 2.75kPa to 5.0kPa LPG or Propane Power Requirement 3 pin earthed 230V power outlet to be within 1.0m of rear left hand corner of the appliance Cavity Construction Cavity Dimensions Cavity for Velo, Quadrato or Cavity for Velo, Quadrato or Quadrato Lite Fascia Quadrato Lite Fascia The cavity size is dependant on fascia type as the Rado fascia is recessed into the wall. Where possible, it is recommended that the cavity is made 5-10mm larger than the dimensions shown to give the installer the maximum amount of space to work in. Cavity for Rado Fascia Cavity for Rado Fascia It is not necessary to line the sides, top or back of the cavity. The wall directly above the Rado fascia must be constructed with non combustible materials, but all other surrounding walls and cavity materials may be constructed with combustible materials. The cavity and surrounding walls for Velo or Quadrato fascias may be constructed using combustible materials. Mantle Clearances Any combustible mantles or protruding ledges above the fireplace must not extend outside the dimensions shown. Ideal Cavity Dimensions (mm): min Velo / Quadrato / Quadrato Lite

Flue Information Horizontal Powerflue Description: The Horizontal Powerflue Wall Terminal must be weather-tight when installation is complete to prevent damage to the dwelling, and must be installed accordance with AS/NZS 5601 and any other relevant building codes. The Horizontal Powerflue connects to the appliance via two Ø100mm and Ø75mm flexible flues. Flue Configurations: The maximum length of flue is 4m and minimum 600mm, and may be run in any variety or combination of directions or angles as required, providing it does not extend past 1.5m horizontally downwards. Where possible, the...