video corpo

AF700
2Pages

{{requestButtons}}

Catalog excerpts

AF700 - 1

AF700 Information Sheet for Builders and Architects FIRE BY | For further information or specifications, visit the technical section of our website www.escea.com | to view the latest product Installation Manual. Appliance Information Product Dimensions All outside dimensions taken from the appliance are with the standoffs attached. Star Rating 3-4 stars Flue Type Flue Size Power Requirement Rear right or front right, 1/2" BSP female thread Natural Gas / ULPG / Propane (Aus) Simpson Duravent Direct Vent (False Chimney) Flexi Flue (Masonry) 3 pin earthed 230/240V power outlet +isolating switch to be within 1.0m of rear right hand corner Distance from fireplace base *Slim Fascia Dimensions. Cavity Construction Cavity Shape The standoff rails installed on the outside must only be re- moved when being installed into a masonry cavity. *Note: If cavity dimensions significantly exceed those spec- ified, a register plate is available for purchase through your bcal escea retailer (New Zealand Only). Cavity Base This appliance MUST be fully supported on its base. The base must extend over the entire area of the underside of the appliance. The base must also be levelled to prevent vibration from possible fan imbalance. M5 Standoffs (circled in the diagram below) may be used to screw in any feet with an M5 thread to level the rear of the fireplace inside the cavity. The base of the cavity must be strong False cavity Installation Cladding (MUST Standoff Rails . Clearances; must cover the full width of the appliance Minimum cavity Minimum cavity Masonry Installation Requirements The masonry install requires a spacer below the appliance to allow room for the fascia to sit flush with the ground. 630315_2 AF700 Builders and Architects Sheet

Open the catalog to page 1
AF700 - 2

Flue Information Vertically terminating flue diagram Clearances Horizontally terminating and vertically terminating with a horizontal offset flue diagram Mantle Clearances Television clearances The following are the recommended minimum clearances for the location of any electrical equipment (such as Plasma TV, LCD TV or home theatre) above an Escea AF700 gas fire. Use either a shelf or mantle below your TV screen or alternatively you can construct a recess to mount your TV screen into. Note: The television clearance recommendations below are to be treated as a suggestion of a suitable...

Open the catalog to page 2

All Escea catalogs and technical brochures

  1. DF960

    2 Pages

  2. DF700

    2 Pages

  3. DF990

    2 Pages

  4. ST500

    1 Pages

  5. IB1100

    2 Pages

  6. IB850

    2 Pages

  7. IB600

    2 Pages

  8. EW5000

    2 Pages

  9. EF5000

    2 Pages

  10. ST900

    1 Pages

  11. FS730

    2 Pages

  12. DX1500

    2 Pages

  13. DX1000

    2 Pages

  14. DL1100

    2 Pages

  15. DL850

    2 Pages

  16. AF960

    2 Pages

  17. Escea brochure

    36 Pages

Archived catalogs