EMAC El toque final Floor/floor. Light/medium loads Novojunta® Pro AL30 is an already assembled system of profiles for structural joints, made of anodized aluminium, which allows movements with six degrees of freedom. It has been designed for joint widths 1-3/16" (30 mm.). This product is intended to be installed after the tiling process (in walls or floors). It is delivered assembled and it's easy to install. Available in silver matt color. General Features R03.001_03/03/2011 Emac Complementos, S.L. reserves the right to make at any time modifications to the geometry profile or the specifications of his products. Reference Hehght wdtnV wdttKby Horizontal movement: Vertical movement: Novojunta® Pro AL30 has a special perimeter piece available: Reference Hehght Jtinay wdthfby Horizontal movement: Vertical movement:

TECHNICAL FILE Novojunta® Pro AL30 Technical Features and tests Alloy Fire resistance Abrassion resistance Very good Focused linear load (rigid wheel track ) Focused linear load(pneumatic wheel track) Emac Complementos, S.L. reserves the right to make at any time modifications to the geometry profile or the specifications of his products. The buildings and constructive elements are under strains caused by thermal variations. The installation of expansion joints helps to minimize the effects that these variations cause in the whole building, preventing a possible structural damage. The CTE (Spanish...

TECHNICAL FILE Novojunta® Pro AL30 Installation Novojunta® Pro AL30, in the same way that the range of Novojuntas Pro® from Emac®, it is delivered already assembled and its installation is very easy. It has been designed for joint widths 1-3/16” (30 mm.) Follow these steps to install succesfully the profile: 1. Clean weall the surfaces where the Novojunta® Pro AL30 is going to be installed. 2. Place the Novojunta® Pro AL30 as you have received it in the joint hollow. Emac Complementos, S.L. reserves the right to make at any time modifications to the geometry profile or the specifications of his...

TECHNICAL FILE Novojunta® Pro AL30 Cleaning and maintenance The cleaning must be done periodically with a soft cloth. If you use a neutral liquid cleaner, you must rinse the profile with cold water and dry to remove excess moisture. If dirtiness persists, clean the profile with a solution with clean water and detergent or neutral soap 5%, brushing with a cloth that has no particles that could scratch the finish. Outdoors, rainfall will clean the profile. The cleaning must be done periodically with a soft cloth. If you use a neutral liquid cleaner, you must rinse the profile with cold water and...