Catalogs >
EMAC >
Novojunta® Pro AL30

Novojunta® Pro AL30
4Pages

Catalog excerpts

Ocasional Floor/floor. Light/medium loads Novojunta® Pro AL30 is an already assembled system of profiles for structural joints, made of anodized aluminium, which allows movements with six degrees of freedom. It has been designed for joint widths 1-3/16" (30 mm.). This product is intended to be installed after the tiling process (in walls or floors). It is delivered assembled and it's easy to install. Available in silver matt color. Material: Length: Packaging: Anodized aluminum 8ft2in / 2,5 m.l. 12 u./box R03.001_03/03/2011 Emac Complementos, S.L. reserves the right to make at any time modifications to the geometry profile or the specifications of his products. Height loint Visible Reference (hg: widthi(a)- widths Horizontal movement: Vertical movement: Technical Features and tests AIM ME INSTITUTO TECNOLOGICO metalmecAnico Fire resistance Abrassion resistance Lightfastness Appearance and color Focused linear load (rigid wheel track ) Focused linear load(pneumatic wheel track) Very good Excellent EN 12373-1

Open the catalog to page 1

TECHNICAL FILE Novojunta® Pro AL30 Aplicaciones The buildings and constructive elements are under strains caused by thermal variations. The installation of expansion joints helps to minimize the effects that these variations cause in the whole building, preventing a possible structural damage. The CTE (Spanish Technical Building Code), in the DB-SAE (Document about actions in building), states that in steel or concrete buildings is necessary not to let continuous elements longer than forty meters without installing expansion joints. Novojunta® Pro AL30 is a solution for expansion joints...

Open the catalog to page 2

TECHNICAL FILE Novojunta® Pro AL30 1. Clean weall the surfaces where the Novojunta® Pro AL30 is going to be installed. 2. Place the Novojunta® Pro AL30 as you have received it in the joint hollow. 3. Remove the protective film and slide the lateral pieces, which will serve to support the profile, until they stop in the edge of the hollow. Be sure that both sides stop in the edge of the hollow, that you use the recommended joint width Emac Complementos, S.L. reserves the right to make at any time modifications to the geometry profile or the specifications of his products. and that the holes...

Open the catalog to page 3

TECHNICAL FILE Novojunta® Pro AL30 The cleaning must be done periodically with a soft cloth. If you use a neutral liquid cleaner, you must rinse the profile with cold water and dry to remove excess moisture. If dirtiness persists, clean the profile with a solution with clean water and detergent or neutral soap 5%, brushing with a cloth that has no particles that could scratch the finish. Outdoors, rainfall will clean the profile. Technical information You can find out more information about the technical features of Emac®’s products by downloading its Technical File in www.emac.es. Emac...

Open the catalog to page 4