Catalogs >
EMAC >
Novojunta® Pro Metal SP50

Novojunta® Pro Metal SP50
3Pages

Catalog excerpts

EMAC El toque final Novojunta® Pro Metal SP50 Novojunta® Pro Metal SP50 is a system of profiles entirely made of aluminum to be installed in overlaid expansion joints up to 50 mm width. Allows multidirectional movements thanks to its design, with ball-and-socket joint system on the side pieces. The size of the side pieces is enough to be safely installed in floorings with the screws supplied. With the visible side striated, is perfect for areas with high traffic thanks to its good resistance of heavy loads and wear resistance. Available with perimeter version. General features R03.001_28/02/2018 Emac Complementos, S.L. reserves the right to make at any time modifications to the geometry profile or the specifications of his products Natural aluminum Joint Visible Profile Horizontal Vertical width (a): width (b): height (h): movement movement Novojunta® Pro Metal SP50 has a special piece available for perimeter installations. Joint Visible Profile Horizontal Vertical width (a): width (b): height (h): movement movement

Open the catalog to page 1

Novojunta® Pro Metal SP50Applications The buildings and constructive elements are under strains caused by thermal variations. The installation of expansion joints helps to minimize the effects that these variations cause in the whole building, preventing a possible structural damage. The CTE (Spanish Technical Building Code), in the db-SAE (Document about actions in building), states that in steel or concrete buildings is necessary not to let continuous elements longer than forty meters without installing expansion joints. Novojunta Pro® Metal SP50 is a solution for structural expansion...

Open the catalog to page 2

TECHNICAL FILE Novojunta® Pro Metal SP50 Installation The reference Novojunta® Pro SP50 is delivered mounted with protective film on the surface. This profile is to be installed on finished floorings. The structural joint width is a requirement that should be specified in the project. Be sure that the profile you choose fulfills the prescribed features. To install the profile follow these steps: 1. Be sure the surfaces to install the Novojunta Pro® Metal SP50 are free from dust and grease. 2. Place the profile on the joint hollow and slide the side pieces until they knock into the joint...

Open the catalog to page 3