FORTE
1Pages

VENTILATED SYSTEM HEAVY FACADE STONE, WITH A THICKNESS GREATER The profiles and components have been drawn to bear extreme loads. Difference in the tension of the installed tile to the different gaps of the fastening elements from the flanges of the tile. Scheme 2 demonstrates the ability of the Forte system to reduce the tensions when the loads are similar. FORTE system is created based on leading Regulations, which are applied by ETEM Building Systems. FORTE is designed based on EIS (ETEM INTEGRATED SOLUTION). EIS is a complex set of procedures and regulations for construction, whose objective is the creation of architectural systems with the highest level of security, optimal design and ease of use. Forte is developed to comply with leading standards norms followed by ETEM Building Systems. All of the ETEM elements are designed within EIS (ETEM Integrated Solution) and are dimensioned using a finite element method with the ANSYS program. Maximum stresses and creeps are pre-simulated. To this end the optimal shape of the profiles and accessories is achieved with assured consistency. The maximum allowed tension, deformations and safety coefficients are as detailed in the numerical values are acceptable according to Regulation 04/3 for building Construction. The FORTE ventilated system for invisible mounting through undercut anchors has the following advantages: A continuous facade with no visible fixing elements Large variety of sizes and designs Highest level of security when fixing the plates due to the Fischer and Keil anchor system. The ability to use cladding materials with a thickness ranging from 8mm to greater than 35mm; Fast and simple installation -1.5 sqm EIS (ETEM Integrated Solution) provides an extremely robust and fully engineered solution that which covers the entire project, and guarantees a complete system proposition. FORTE Ventilated System uses FISCHER and KEIL fixing anchors to secure the connection between the facade material and the main load bearing structure of the system. The unique undercut technology for drilling and mounting of the anchor on the rear {secret fix) section of the facade material allows for: • Use offagade materials with a thickness more than 20mm • 50% greater load in comparison to standard methods of hanging heavy fagade materials (marble, granite) • 73% reduction in internal stresses in the panel Difference in the stresses on the tile occur when: 1. Fixing with clamps or using rivets (self drilling screws) 2. Utilizing "Undercut" anchors SYSTEM PROFILES AND ACCESSORIES The system is equipped with finishing profiles and special accessories, allowing the accomplishment of unique details, finishing and transition to other cladding materials. joint profile thermo break horizontal profile adjustable hanger fixed point adjustable hanger flexible point hanger flexible point chemical anchor threaded rod plastic sieve self drilling screw undercut anchors