EcoLED Flexi-Strip Flexi-Strip is a range of self-adhesive LED light tape allowing the creation of stunning lighting effects. It can be easily attached to most surfaces and provides maintenance-free background lighting in almost any interior or exterior application. How To Specify ECOLED’s Flexi-Strip A Flexi-Strip part code will typically read as GIBVF60WSWW. By dividing up the part code you can specify your requirement as follows: LEDS/metre Hi-Power (X) Non IP IP65 (WS) IP68 (WTE) Side Emitting (SE) GIBVF 60 WS Becomes GIBVF60WSWW which is Flexi-Strip, 60 LEDs per metre, IP65 (front sealed) in Warm White Light Colour. GIBVF 60 X Becomes GIBVF60XVWW which is Flexi-Strip, 60 LEDs per metre, not IP rated Hi Power in Very Warm White Light Colour. Flexi-Strip is not IP rated as standard. The IP65 version is sealed from the front only and remains self adhesive whereas the IP68 version is sealed front AND back and is not well suited to self adhesion in which case mounting clips will be provided. If you require the IP rated strip, use the WS or WTE part codes to specify the type. Colour & Viewing Guide W - White 6000K WW - Warm White 3500K VWW - Very Warm White 2700K RGB - Colour Change R - Red G - Green B - Blue PNK - Pink P – Purple A – Amber Y – Yellow. Please note we generally stock single colour White, Warm White and Blue as well as RGB. Other single colours are available to special order. FlexiStrip has a typical viewing guide of 120°. 68 Power Guide According to the number of LEDs per metre each type has a different power consumption in Watts. To decide on the Power Supply Unit required, simply add up the number of metres on the circuit and multiply that by the Wattage per metre to calculate the total load. Then, specify the Power Supply Unit with an output value greater than that number. So, 60 LEDS per metre in single colour uses 5W per metre. Three metres = 15W therefore, an 18W PSU will be required as the load is too high for the 12W. Below we show the approximate Watts per metre of the different types of Flexi-Strip. Please note all EcoLED FlexiStrip runs on 12Volts DC unless otherwise stated. 24Volts DC is available to order. 30 LEDs/ Metre 60 LEDs/ Metre 60 LEDs/ Metre X Hi-Power 60 LEDs/ Metre RGB 120 LEDs/ Metre 2.5W per metre 5W per metre 15W per metre 15W per metre 10W per metre 12V DC Power Supplies Available in the following outputs:12W, 18W, 25W, 60W, 100W, 150W, 200W Continued on Page 70 >

EcoLED Flexi-Strip Cutting & Configuring Flexi-Strip can be cut and configured to suit many different applications. 30 LEDs per metre can be cut every 100mm, 60 LEDs per metre every 50mm and 120 LEDs per metre every 25mm. Care should be taken by the installer to re-seal and protect the integrity of the joins when cutting and configuring the IP versions. Flexi-Strip Specification Table The following table shows the types of Flexi-Strip that ECOLED typically holds in stock: GIBVF 30 • GIBVF 60 • GIBVF 60 GIBVF 60 • • GIBVF 120 • Please note that ECOLED does not recommend running more than 10M of...