ECO-120 Embedded solar studs E c o - In n o v 523 rue de la Béalière - 38360 Noyarey - France Tel: +33 438 70 00 27 - Fax: +33 438 49 21 36 [email protected] - www.eco-innov.com Photos not contractually binding. Eco-Innov reserves the right to modify the technical characteristics of its products without notice.

INNOV' Embedded solar studs / ECO-120 • Autonomous LED beaconing • Suitable for pedestrian or cycle ways • Easy maintenance of electrical unit • 1 vertical LED for a 360° visibility • LED colour : cool white, warm white, blue, green, red or amber • 16 reflective glass beads Photos not contractually binding. Eco-Innov reserves the right to modify the technical characteristics of its products without notice. 05/05/2017 10:23:44

Embedded solar studs / ECO-120 Characteristics TECHNICAL CHARACTERISTICS Dimensions and weight Diameter : 120 mm. Total height: 41 mm. Height above roadway: 5 mm in the center. Weight: 560g. Materials Polycarbonate, aluminium, stainless steel, monocrystalline silicon. Recycling managed by RECYLUM* Energy storage Rechargeable Ni-Mh battery (up to 210h of autonomy). Lifespan and guarantee Average lifespan more than 5 years. 2-year guarantee** Working temperature range -20°C a +80°C Protection indices IP 68 (watertightness). IK 10 (impact resistance). Pressure resista nce Suitable for lanes occasionnaly...

Embedded solar studs / ECO-120 LIGHTING CHARACTERISTICS Vertical beaconing with one LED for a 360° visibility. LED colours: cool white, warm white, blue, green, red or amber. Constant or blinking beaconing (other possibilities on request). 16 reflecting glass beads in addition. * In the framework of our commitments as a producer of professional WEEE (see section on recycling Recyclage). ** The guarantee applies in the event of complete failure of the self-contained lighting system during normal usage. It covers replacement of the faulty article with an identical model delivered free of charge...

Embedded solar studs / ECO-120 Installation 1 - After deciding where the studs are to be installed, drill a hole with a minimum diameter of 130 mm and 40 mm deep. 2 - Carefully brush and clean the hole to remove any dust and traces of damp that would affect the efficiency of the adhesive. 3 - Pour the bonding adhesive into the hole to about 2/3 of its height. We recommend using Sikadur 30 two part epoxy adhesive. 4 - Press the stud into the adhesive, using the support brackets. 5 - Remove any residual adhesive with a dry cloth and leave it to set for several hours depending on the ambient temperature...