TECHNICAL DATA SHEET PLUS Reinforced tile adhesive Cementitious and flexible white adhesive for tiles and granite, reinforced with acrylic resins. Its high plasticity distinguish the product for its high adhesive strength and zero vertical slip. Its high thixotropy allows for coatings in thicknesses of up to 12mm thick without sagging and it has an extended open time. Classified C2TE S1 per ΕΝ 12004 and EN 12002. The product has received an Environmental Product Declaration (EPD) following an assessment of the environmental impact of its life cycle. Registration number: S-P-13557, The International EPD® System. APPLICATIONS PLUS is suitable for installing large size tiles, as well as thin slabs of low and non absorbent granites of all types, in bathrooms, showers, fountains, wet outdoor areas, and floors subject to particular stress. It is suitable for heavy traffic areas such as car showrooms, airport terminals, shopping malls. Also recommended for floor applications over mosaic or weathered tiles. Use it for both interior and exterior applications. Adding DUROSTICK ACRYLIC EMULSION in the mixing water, at a ratio of 1:1, further improves its characteristics. USE 1. Surface preparation The application surface has to be sound, clean, free of loose materials, dust, paint, grease and oils. The surface has to be soaked before the application. It is necessary to prime all absorbent substrates and aircrete, using either the ACRYLIC EMULSION or D-20 The technical specifications and directions of use contained in this technical data sheet are the results of the knowledge and experience of the company's research and development department, as well as from the real-life applications of the product. The recommendations and suggestions regarding the use of the products are made without guarantee since the respective conditions during their application are beyond the control of the company. For this reason, it is the user's responsibility to make sure that the product is suitable for the intended application as well as the application conditions of the project.

TECHNICAL DATA SHEET PLUS Reinforced tile adhesive of DUROSTICK, at a mixing ratio of 1:1 with water. It is necessary to prime all cement boards using either the micromolar stabilizer AQUAFIX or SOLVENT BASED PRIMER of DUROSTICK. Lightweight or else, unsound cement screeds, must necessarily be primed with DUROSTICK ACRYLIC EMULSION or D-20 at a ratio of 1 part additive to 2 parts water or 1 part DUROMAX to 5 parts water. Follow all balcony and terrace, bathroom and shower, fountain and swimming pool applications by coating the substrate with HYDROSTOP FLOOR, with 2-3 successive, crosswise coats...

TECHNICAL DATA SHEET PLUS Reinforced tile adhesive TECHNICAL SPECIFICATIONS (Measurement conditions 23°C and 50% R.H.) Form - Color Cementitious mortar - White Bulk density of dry mortar Water requirement Application temperature Temperature resistance Application thickness Time for minor adjustments 30 minutes* Grouting After 4-8 hours on wall, after 24 hours on floor Foot traffic PRODUCT PERFORMANCES Adhesion strength, per ΕΝ 1348, after: ● 28 days ● Water immersion for 21 days ● 25 freeze - thaw cycles * Depending on the weather conditions (temperature, humidity). NOTE: The product exceeds...