TECHNICAL DATA SHEET D-65 Self levelling fast setting cement screed for levelling floors, for thicknesses of 1-10mm Pourable, self-levelling cement screed for levelling floors in thicknesses of up to 10mm. It is fast-setting and curing, without any shrinkage-related cracks. Distinguished for its high mechanical strength against abrasion, compression, impact and deterioration. Also distinguished for its strong adhesion to any mineral substrate. It presents excellent rheology, workability and has the ability to be pumped. Classified CT-C30-F6-AR2, per EN 13813. The product has received an Environmental Product Declaration (EPD) following an assessment of the environmental impact of its life cycle. Registration number: S-P-13769, The International EPD® System. APPLICATIONS D-65 is ideal for levelling and smoothing of concrete floors, cement screed or existing mosaic floors to be lined with marble, tiles, vinyl flooring, carpet, hardwood flooring, microcement, etc. Suitable for interior floor applications. 1. Surface preparation Make sure substrates are stable (strong, sound), without cracks, gaps and free from loose materials, dust, oils and grease. It is necessary to prime all absorbent substrates with the micromolar stabilizer AQUAFIX of DUROSTICK. It is necessary to prime all non-absorbent substrates with the quartz based bonding primer DS-290 of DUROSTICK. Pour the product after the primer has dried thoroughly (approximately 2 hours later). 2. Application Empty the mortar into a clean container with cool water, at a ratio of 4.5-4.75lt water to 25kg mortar, and mix with a low-rpm drill, until a lump-free, homogeneous mass is created. Allow the mixture to mature for 1-2 minutes and mix again. Starting from a corner, apply the product using a floor squeegee or a wide notched trowel, and assist into distributing the product evenly on the entire floor. The technical specifications and directions of use contained in this technical data sheet are the results of the knowledge and experience of the company's research and development department, as well as from the real-life applications of the product. The recommendations and suggestions regarding the use of the products are made without guarantee since the respective conditions during their application are beyond the control of the company. For this reason, it is the user's responsibility to make sure that the product is suitable for the intended application as well as the application conditions of the project.

TECHNICAL DATA SHEET D-65 Self levelling fast setting cement screed for levelling floors, for thicknesses of 1-10mm Remove any air bubbles using a wide, stiff street broom or a spiked floor roller. NOTES • For larger thickness applications and up to 30mm, use the self-levelling cement screed D-64 of DUROSTICK. • Do not use the product when it begins to set. The mixture should not get remixed with additional water. • Do not add anything into the mortar (cement, gypsum, hydrated lime or regular lime, etc.) or improving additives. • Do not apply on substrates affected by rising damp. • The screed...