TECHNICAL DATA SHEET D-38 Two component construction epoxy putty - adhesive Professional adhesive of gray color without solvents in putty form. The product features a breaking point that is greater than concrete. It has high adhesion properties. It is highly resistant to acids, alkalis, salts, and salt (sea) water, while it does not shrink. Classified as a structural bonding product to concrete per EN 1504-4 and RG per EN 13888. APPLICATIONS D-38 is used to repair concrete defects and seal cracks that will be injected with the epoxy resin DUROSTICK D-33. It is suitable for bonding similar and dissimilar construction and industrial materials, such as metal, polyester, glass, stone, fiber reinforced cement screeds etc. It is also suitable for anchoring expansion rebars and equipment as well as fastening metal formwork around concrete columns. The products is also suitable for coating and sealing-restoring defects and damage of industrial floors. 1. Surface preparation All application surfaces must be free from loose materials, dust, oils and moisture. 2. Application preparation Empty the plastic tube containing the hardener B, into the container with the resin A. Mix thoroughly for 5 minutes using a thin, metal putty knife until the mixture is smooth and of solid gray color. It is important to thoroughly scrape the bottom and the side walls of the container during the mixing process, to evenly distribute the hardener into the entire resin mass. 3. Application Apply the mixture using a putty knife or a gauging trowel. Remove the excess product using DUROSTICK THINNER 201, immediately after use. When applying over cracks, allow for 24 hours to pass before injecting DUROSTICK D-33 resin into the crack cavity. The technical specifications and directions of use contained in this technical data sheet are the results of the knowledge and experience of the company's research and development department, as well as from the real-life applications of the product. The recommendations and suggestions regarding the use of the products are made without guarantee since the respective conditions during their application are beyond the control of the company. For this reason, it is the user's responsibility to make sure that the product is suitable for the intended application as well as the application conditions of the project.

TECHNICAL DATA SHEET D-38 Two component construction epoxy putty - adhesive 1.8kg/m²/mm thick coat. CLEANING Clean all tools with THINNER 201 of DUROSTICK, immediately after use. TECHNICAL SPECIFICATIONS Chemical base Color Thixotropic paste Viscous liquid Store in dry and shaded places, in the original and factory sealed container, for 12 months from production date. SAFETY DIRECTIONS The product is classified as irritant and corrosive. It is recommended to keep away from the reach of children. Before use, refer to the cautions on the product packaging or the Safety Data Sheet. Component density...