DURAPLUS
2Pages

Since the usage and finishing of the product is not under our control, we accept no liability for the success of the work and can therefore only guarantee the nature of our products as per the accompanying product data sheets and in accordance with our general terms and conditions of sale. The properties listed here represent no guarantee with respect to the eventual use of our products. We reserve the right to make changes due to technical advances. Any other technical information given in the course of a consultation must be confirmed in writing. Colours shown here are restricted by the printing techniques and may differ from those exhibited by the products themselves. We also reserve the right to make alterations to the product technology or design. Only the current version of this data sheet is valid. Such versions are accessible by anyone via the internet. The issue of the latest data sheet invalidates all those that have been published beforehand. Rectangular Trims - Information Sheet - APPLICATION: DURAPLUS profiles by Dural have a visible 8 mm width surface area and were developed for improved visual joint design. The application is recommended wherever the flooring material must meet a high aesthetic requirement. For example, show rooms or art galleries. DURAPLUS facilitates a clean separation of different flooring materials, or areas. Besides the decorative function, DURAPLUS provides the edges of the floor with the maximum protection from impact damage. DURAPLUS is also available in a flexible version - “Z-Flex“. MATERIAL: Internal/external corner The following versions of the profiles DURAPLUS are available: aluminium natural; aluminium anodised; Aluminium high gloss anodised; brass natural; brass high gloss finish („Star“ with peel-off strip); brass chrome-plated („Star“ without peel-off strip); stainless steel natural; stainless steel polished („Star“ with peel-off strip); stainless steel high gloss („Star“ with peel-off strip). Stainless steel Mat. V2A (304, Material number 1.4301). PROPERTIES: DURAPLUS profiles of brass are appropriate for use in domestic and industrial areas. They are resistant to major stresses and mostly resistant to chemicals generating during the laying of tiles. Important: brass oxidizes when exposed to air, especially with high humidity. The surface is covered with a patina (protective layer) and changes its appearance. DURAPLUS profiles of aluminium are applicable wherever no exceptional chemical reactions are expected. Careful handling of cement materials is required to avoid corrosion. Because aluminium is sensitive to alkaline media‘s all residues of mortar, tile cement or joint cement have to be immediately removed from all visible surfaces. The profile is to be completely embedded into the contact layer. This avoids cavities to generate where alkaline water might accumulate. EXP

DURAPLUSRectangular Trims- Information Sheet - DURAPLUS profiles of anodised aluminium are of special refinement and therefore the surface is usually not subject to changes. The visible surfaces however, must be protected against any cement materials. Damages can generate because of scratching or abrasion. DURAPLUS profiles of stainless steel are especially suitable for areas subjected to high stresses due to chemicals and acids. They meet highest requirements of resistance to mechanical impact. Stainless steel profiles are used in foodstuff industry, swimming pools, in hospitals and...