DURABAK_BK
4Pages

Since the usage and finishing of the product is not under our control, we accept no liability for the success of the work and can therefore only guarantee the nature of our products as per the accompanying product data sheets and in accordance with our general terms and conditions of sale. The properties listed here represent no guarantee with respect to the eventual use of our products. We reserve the right to make changes due to technical advances. Any other technical information given in the course of a consultation must be confirmed in writing. Colours shown here are restricted by the printing techniques and may differ from those exhibited by the products themselves. We also reserve the right to make alterations to the product technology or design. Only the current version of this data sheet is valid. Such versions are accessible by anyone via the internet. The issue of the latest data sheet invalidates all those that have been published beforehand. Balcony angle profile with drip edge With 60 mm facing Properties and installation: The Durabal-BK edge profile is made of anodized aluminium and has an inclined drip edge. Durabal-BK edge profiles provide the optimum finish for balcony and patio edges with regard to both visual appeal and technical maturity. Dural BK profiles are available with a vertical facing height of 18 / 20 / 22 or 60 / 62 / 64 mm, allowing the entire visible edge of the balcony construction (depending on the flooring height) to be concealed and effectively sealed against moisture, dirt and the growth of moss. External corner Before the tiles are laid, the Durabal-BK edge profiles are pressed into the combed thin-bed mortar (DIN EN 12004 / C2) along their entire length and properly aligned. For humidity regulation purposes, an adequate gap must be left between the vertical facing section of the profile and the edge of the balcony. Internal corner Connector DURAL GmbH & Co. KG Südring 11 Profile with 60 mm facing height and connector

Balcony angle profile with drip edge The Durabal-BK edge profiles are joined together using special aluminium connectors, which prevent unsightly steps in the profile alignment at the butt joints. A small gap of approximately 1 mm must be left between the ends of the profiles to prevent stresses in the material. Specially manufactured corner pieces are used to create elegantly and optimally designed inside and outside corners. The corner pieces can be used with flooring heights of 9, 11 and 13 mm. The Durabal-BK edge profiles can also be used to face the vertical edges of balconies and...

Balcony angle profile with drip edge Care must also be taken to ensure that cement removers used to clean the surface of the ceramic tiles do not come into contact with the surface of the profiles. Protective measures must be taken, in this case, to prevent any damage to the surface. To conserve the elegant appearance of the profiles in the long term, we recommend regular cleaning using a neutral cleaning agent (with a pH value between 6.5 and 7.5) that is non-abrasive. As a rule, regular cleaning with lukewarm water and a clean linen cloth is sufficient. Vertical installation 9/11/13 mm...