FLAT MATT LIGHT & SPACE Dulux Trade Flat Matt Light & Space uses revotutionary Lumitec technology that helps reflect up to twice* as much light around the room, making even the smallest rooms look and feel more spacious compared to our conventional emulsion paints with a similar hue (colour family) and chroma (intensity of colour). *The light reflectance value is always greater than our conventional emulsion paints but may not reflect twice as much light in every case, depending on the colour chosen. • Light Reflective • High Opacity, Flat Matt Finish • Reflects up to Twice as Much Light* PRODUCT INFORMATION Typical Use Suitable for interior use on all normal interior wall and ceiling surfaces. For interior areas that are likely to suffer from mould growth, use Mouldshield Fungicidal Eggshell from Dulux Trade*. Pack Size 5L only. Colour Range Absolute white only. Film Properties Chemical Resistance: Not suitable. Heat Resistance: Not suitable for use on heated surfaces, such as radiators. Water Resistance: Where surfaces are subject to a high degree of wear and tear and require a greater level of washability, Dulux Trade Diamond Eggshell is more suitable. Composition (nominal) Pigment: Lightfast Pigments. Binder: Acrylic Copolymer Emulsion. Solvent: Water. Volume Solids White - 34% (nominal). Other colours will vary. SURFACE PREPARATION To get the best results with Dulux Trade Flat Matt Light & Space, make sure surfaces to be painted are sound, clean, dry (new surfaces particularly must be fully dry). Remove all loose and defective paint. Special precautions should be taken during surface preparation of pre-1960s paint surfaces over wood and metal as they may contain harmful lead. Where necessary, wash the surface to remove dirt, grease and powdery or dusty residues. Rinse with clean water and allow to dry. Seal surfaces that remain powdery after thorough preparation with an appropriate plaster sealer. Where necessary, rub down and then wipe off with a damp, lint free cloth to avoid dust. Any surface defects should be filled with the appropriate Polycell Trade Polyfilla. SYSTEMS INFORMATION STIR THOROUGHLY BEFORE USE. Seal new or bare surfaces with a thinned first coat of Dulux Trade Flat Matt Light & Space (up to 1 part clean water to 5 parts paint). The normal finishing process is 2 full coats of Dulux Trade Flat Matt Light & Space but on previously painted surfaces in good condition where similar colours are used, 1 coat may be sufficient. APPLICATION METHOD Brush, roller, conventional spray or airless spray. As with other water-based paints, do not apply in temperatures below 8°C (as recommended by the British Standard BS 6150). Practical Coverage A guide to the practical coverage which can be achieved under normal conditions is up to 17m2 per litre.

FLAT MATT LIGHT & SPACE Thinning Sealing new or bare surfaces: Add up to 1 part clean water to 5 parts paint. Normal use (not to be exceeded): Add up to 1 part clean water to 10 parts paint. Conventional spray application: Add up to 1 part clean water to 2.5 parts paint. Airless spray application: Add up to 1 part clean water to 5 parts paint After use, remove as much product as possible from equipment before cleaning with water. Spray Recommendations Transportation & Storage Conventional Spray: Satisfactory through most equipment. Airless Spray: A typical set up for airless spray would be a...