750ml INSTA-STIK roofing adhesive
8Pages

{{requestButtons}}

Catalog excerpts

750ml INSTA-STIK roofing adhesive - 1

Building Solutions insulation boards roofing adhesive .

Open the catalog to page 1
750ml INSTA-STIK roofing adhesive - 2

INSTA-STIK roofing adhesive in a can: for highly portable and economical adhesion The 750ml INSTA-STIK™ roofing adhesive can has been designed to offer quick and economical installation of roof insulation boards on small flat roofing projects. Each can contains enough adhesive to adhere up to 14m2 of insulation board (based on 19-25mm beads at 300mm centres), and comes with optional gun sizes: a standard short barrel foam gun and a 100cm long barrel foam gun. The re-useable guns offer easy, quick yet controlled application and the adhesive is dispensed as foam which ‘cures’ within 20 to 30...

Open the catalog to page 2
750ml INSTA-STIK roofing adhesive - 3

Features and benefits of 750ml INSTA-STIK roofing adhesive ››› Economical can size with minimal wastage ››› Quick and easy to apply with controlled application ››› Re-usable applicator guns in two sizes ››› Fast curing and strong bond strength ››› Short preparation time – no heating required ››› No primer needed ››› Safety: no hot works, naked flames, noise or vibration in use ››› Cleanliness: no fumes or dust in use ››› No damage to substrate from mechanical fixings ››› No visible fasteners on the underside of the substrate ››› Can be used on vertical substrates such as upstands ››› No...

Open the catalog to page 3
750ml INSTA-STIK roofing adhesive - 4

INSTA-STIK roofing adhesive dispensed from a 750ml can is compatible with the following insulation boards: ››› Bituminous felt faced boards ››› Cork insulation boards ››› Cellular glass insulation boards ››› Expanded polystyrene boards (EPS) ››› Extruded polystyrene boards (XPS) ››› Glass tissue faced boards ››› Rock fibre boards ››› Wood fibre boards INSTA-STIK roofing adhesive dispensed from a 750ml can is compatible with the following vapour barriers and substrates: ››› Bituminous vapour control layers ››› Concrete decks ››› Galvanized metal decks ››› Mastic asphalt ››› Oriented strand...

Open the catalog to page 4
750ml INSTA-STIK roofing adhesive - 5

Guidance on INSTA-STIK application Table 1 - GUIDANCE ON INSTA-STIK BEAD SIZE AND SPACING FOR ATTACHMENT OF INSULATION BOARDS Building height (m) 0 - 6.0 6.0 - 12.5 12.5 - 21.5 21.5 - 30.5 Coverage is up to 14m2 of insulation per can of INSTA-STIK for 19-25mm wide beads at 300mm spacing. The above centres are based on an adhesive bond strength of 1.5kN/m bead length (19-25mm width) between substrate and insulation. Because of greater wind pressures exerted in perimeter areas, it is recommended that fixing should be increased in such zones. Table 2 - GUIDANCE ON INSTA-STIK BEAD SIZE AND...

Open the catalog to page 5
750ml INSTA-STIK roofing adhesive - 6

How to use 750ml INSTA-STIK roofing adhesive Before applying INSTA-STIK roofing adhesive: ››› Surfaces should be firm, clean, and free of dust, grease or loose particles. Wear suitable protective eyewear and gloves. ››› ››› To speed up the curing process, the adhesive beads can be lightly misted with water. Please note: Moisture is needed for an even and rapid curing of the adhesive. 1 Shake the can vigorously for 30 seconds. 2 Screw the threaded end of the gun onto the valve. 3 During dispensing the can must be held inverted with the valve in bottom position. To extrude the foam, pressure...

Open the catalog to page 6
750ml INSTA-STIK roofing adhesive - 7

How to use 750ml INSTA-STIK roofing adhesive 8 Fresh foam spills must be removed immediately within the Tack-Free time using INSTA-STIK POLYURETHANE GUN CLEANER, or similar cleaning solution. Once foam is cured, it may be removed mechanically. 9 If working on small areas with intervals, during the intervals leave the gun dispenser on the INSTA-STIK can and turn the screw on the back of the gun clockwise until it stops. Reverse when re-starting adhesion process. 10 When a can becomes empty, immediately screw the gun onto another can, cleaning it with gun cleaner if necessary. Following...

Open the catalog to page 7
750ml INSTA-STIK roofing adhesive - 8

Note: The information and data contained in this brochure do not represent exact sales specifications. The features of the products mentioned may vary. The information contained in this document has been provided in good faith, however Dow excludes as far as possible any liability relating to it and does not give any guarantee or assurance of product performance. It is the purchaser’s responsibility to determine whether these Dow products are suitable for the application desired and to ensure that the site of work and method of application conform with current legislation. No licence is...

Open the catalog to page 8

All Dow France catalogs and technical brochures