TECHNICAL DATA SHEET PARAFOAM PANELGLUE 1K CHARACTERISTICS • Ready to use manual one-component PU foam adhesive • Glued parts are chargeable after 2 hours • CFC- and HCFC- free (ozon friendly) • Adheres well to all common building materials • Low post-expansion and expansion pressure APPLICATIONS • Bonding of insulation panels based on polystyrene (XPS, EPS) and polyurethane (PUR and PIR insulation panels) for (exterior) fagade and wall insulation. • Bonding of wall panels in indoor applications such as MDF, plasterboard boards, gyproc, composite sheets and OSB panels. • Bonding of aerated concrete blocks in non-load bearing inner walls. • Bonding of window sills. • Filling joints and cavities between insulation panels (if not exposed to UV rays). Technical data according to test metnoas approved oy feica. inese test metnoas are designed to provide transparent and reproducible test results, giving an accurate representation of product performance. The FEICA OCF test methods are available at http://www,feica,eu/our-industrv/pu-foam-ocf,aspx, FEICA is the multinational association representing the European adhesive and sealant industry, including the producers of one-component foam manufacturers More information at www.feica.eu. 12 cans of 750 ml/box - 56 boxes/pallet This technical data sheet replaces all previous editions. The data on this sheet have been compiled according to the last laboratory report. Technical characteristics can be changed or adapted. We are not responsible for any incomplete information. Before use, one needs to ensure that the product is suitable for his application. Therefore, tests are necessary. Our general conditions apply. DU CHEMICALS 5 Manufacturer of Sealants

METHOD OF USE Preparation • Use only in well-ventilated or open areas. • The substrate must be flat, solid, dry and clean, with no dust, grease, sinter layers, weathering, mortar residue, etc. Check that the substrate has sufficient load-bearing capacity. Check the adhesion of existing coatings. Non-load-bearing layers or loose parts should be removed. Pre-treat powdery substrates with a suitable fixing agent. • In case of doubt, a test should be performed to determine the suitability of the substrate. • Slightly moistening dry surfaces promotes curing and adhesion. • Chilled cans must be carefully...

BONDING OF AERATED CONCRETE BRICKS FOR NON-LOAD-BEARING INTERNAL WALLS • Parafoam Panelglue 1K is suitable only for the bonding of aerated concrete blocks on non-load-bearing inner walls with a maximum height of 3 m (= 1 storey height). The adhesive foam can be used only when an even distribution of loads from block to block is ensured. • The bottom row of bricks should be placed with mortar to make them perfectly level. • For the subsquent rows of bricks, apply the adhesive foam in two beads of 30 mm diameter parallel to the brick edge (± 3 to 4 cm from the edge) on both the horizontal and vertical...