IMPASSA Self-Contained 2-Way Wireless Security System Quick-Start Installation Guide 1. Remove the Front Plate Using a small screwdriver, insert in the bottom left and right-hand slots and gently pry to separate the front panel. 2. Mount the Back Cover Begin by routing telephone line wiring, Input/Output wiring and AC power wiring through the cutout in the back cover. Determine placement location and mount the back cover to the wall using the screws and drywall plugs. Note: For versions supporting cellular communications, the cellular signal strength can be first checked in section [850], to determine the optimal location to mount the unit. 3. Connect Wiring Connect wiring to the terminal block on the back cover. 4. Connect the Battery Connect the battery cable to the connector on the PCB, ensuring proper orientation of the connector. 5. Attach the Front Cover Place the top portion into the back cover first and press the bottom portion into the back cover to snap into place. panels, keypads & modules Contact your DSC distributor. www.dsc.com | 1-888-888-7838

6. Power Up the System Apply power by plugging in the transformer. 7. Enrol Wireless Devices Using the quick enrol feature found in section [898], wireless devices can be enrolled into the IMPASSA system easily. 8. Template Programming The functions required for basic operation of the IMPASSA system can be configured (4-digit code) quickly through the use of template programming in section [899]. Code prompts exist for pre-defined zone definitions, reporting code formats, communication call directions and DLS setup. Once the code has been programmed, you will be prompted to enter the monitoring...