4. At the corners of the eaves, the installation may be done as follows: SOFFIT panel, vented SOFFIT panel, vented ENJOY BUILDING WITH US! SOFFIT panel Facade wall SOFFIT panel Facade wall The fasteners required for the installation are corrosion protected nails with a length of no less than 20 mm and head diameter not smaller than 8 mm. Fasteners should be driven into the middle of the SOFFIT holes, leaving a clearance of 1-2 mm so as to allow elements to move freely, due to temperature SOFFIT panels can also be installed using flat-head screws. To ensure proper ventilation of the roof, after each two full SOFFIT panels should be installed a vented SOFFIT panel. The effective coverage width of the SOFFIT panels is 20,3cm. The quality of all elements should be checked before their installation. The new look of your home VINYL SOFFIT System SOFFIT LENGTH DEPENDING ON THE AMBIENT TEMPERATURE DURING INSTALLATION After installing the „J“ profile along the eaves it is necessary to define the length of SOFFIT panels which are recommended to be installed perpendicular to the eaves. The length of the panels is defined by the distance between the inner walls of the „J“ profile. It is important to take into account the ambient temperature at the time of assembly in order to determine the required clearance for thermal expansion of the material. In case the distance between the inner walls of the „J“ profile is up to 1m, the SOFFIT panels must be cut by 5 mm less, in order to provide the necessary clearance for thermal expansion. In case the distance between the inner walls of the „J“ profile is greater than 1m, to define the length of the SOFFIT panels and the necessary clearance for thermal expansion, you can refer to the following table: PACKAGING All elements of the system are 3 meters long and are packed in carton boxes. STORAGE AND TRANSPORTATION System SOFFIT should be stored in closed and ventilated premises in a horizontal position along the entire length. Height of stacked boxes must not exceed 1m. The temperature in the premises should not exceed 50˚C. Do not cover with protective foils and do not allow exposure to direct sunlight, which can result in deformation of the products. During transportation the goods must be well fastened. Wooden pattern laminated SOFFIT ENJOY BUILDING WITH US! DEVOREX Ltd., Bulgaria, Plovdiv Region 4109 Brani pole, Zone Chiirite 020 G (South Ring road of Plovdiv, Bulgaria) Tel.: (+359) 32 677 105, (+359) 32 677 205 Fax: (+359) 32 677 305 e-mail: [email protected]

VINYL SOFFIT INSTALLATION The SOFFIT system should be assembled on the wooden grill using nails or screws with large head. It is necessary to leave a small clearance between the nail/screw head and the surface of the SOFFIT in order to ensure the thermal expansion of the material. The installation should be performed at temperature higher than 0°C. The SOFFIT system should be used only for lining the eaves of buildings. System SOFFIT is an excellent lasting and aesthetic solution for finishing pitched roofs. It is designed for lining the roof eaves while ensuring their appropriate ventilation....