DERBIBRITE NT
1Pages

The white reflective bituminous waterproofing membrane DERBIBRITE NT is a waterproofing membrane composed of a copolymer bitumen with New Technologies which give it exceptional characteristics. DERBIBRITE NT is reinforced with a composite glass / polyester reinforcement impregnated with an acrylic coating with a high reflection capacity.  The functionality of the DERBIBRITE NT as a passive cooler allows energy savings and    reduce production of CO2 during its roof life DERBIBRITE NT benefits from a technology that makes it pH-neutral thus allowing the recycling of rainwater. When installing the DERBIBRITE NT a minimum slope has to be provided in accordance with the national rules and the requirements described in the specifications. The membrane also has a border of 10 cm without coating to facilitate the application. Special characteristics SRI (Solar Reflectance Index) Initial reflectivity Initial emissivity Fungus resistance Fire resistance ASTM 1980 100 ASTM C-1549 81% (Criterium > 65 %) ASTM C-1371 & ASTM E-408 81% (Criterium > 80 %) ASTM Test method G 21 0 (no growth of fungi) Conform to EN 13501-5, classification BROOF (t1, t2, t3) according to CEN/TS 1187 method. Fire resistance reports available upon request. Environmental characteristics pH-neutral Recycling Climatic change* Ecological Resistant Anti-tearing HALOGEN FREE Halogen free In accordance with ISO 14040 standard (Life Analysis Cycle) U1.3/01-080 (MFPA Leipzig) this waterproofing membrane is 100% recyclable 3,4kg CO2/m² but its functionality allows it to comply with the criterion Factor 19 > Factor 4 Factor 4 : European objective that falls within the development of an European strategy for sustainable development in line with the kyoto protocol. It means that by 2050 the products will have to generate twice more value with 2 times less ressources Factor 19 : Due to its passive cooling effect DERBIBRITE NT saves 19 times more CO2 after installation than the produced total of CO2 during production. Fire resistant pH-neutral Reflective * Values according with ISO 14040 standard and approved by Ecobilan (report available if required) This document cancels and replaces any other document previously published In order to improve his products, the manufacturer reserves the right to change them without prior notice Technical characteristics Heat resistance Cold bending Tensile strength L/T Dimensional stability Tear resistance L/T Resistance to static load MLV : Manufacturer Limited Value / Presentation Thickness Length Width Surface Armature composite glass/polyester Acrylic coating Roll weight Number of rolls per pallet Test method Expression of value EN 1110 MLV EN 1109 MLV EN 12311-1 MDV (±20%) EN 1107-1 MLV EN 12310-1 MLV EN 12730(A) MLV MDV : Manufacturer Determinated Value Test method EN 1849-1 EN 1848-1 EN 1848-1 Storage Rolls must be transported and stored in a vertical position, off the ground.