4400 Series
28Pages

Compact Refrigerators 4400 Series Specifications, Installation, Operation & Maintenance Manual This manual is updated as new information and models are released. Visit our website for the latest information. Read this instruction before operating this equipment. Part Number: 9295093A 02/21 Original Document

Safety Notices nWarning nWarning Read this manual thoroughly before operating, installing or performing maintenance on the equipment. Failure to follow instructions in this manual can cause property damage, injury or death. DANGER Do not install or operate equipment that has been misused, abused, neglected, damaged, or altered/modified from that of original manufactured specifications. DANGER Never stand on the unit! They are not designed to hold the weight of an adult, and may collapse or tip if misused in this manner. DANGER Keep power cord AWAY from HEATED surfaces. DO NOT immerse power...

Section 1 General Information Serial Number Information Model Numbers The serial number is on the identification plate that also includes the model number. The identification plate is located near the top front corner of the left interior wall. This manual covers the following models: Always have the serial number of your unit available when calling for parts or service. 4427NP-6 One Door Salad Top 4427NP-8 4427NP-9M 4427NP-12M One Door Mega Top 4432NP-12M 4448NP-6 4448NP-8 Two Door Salad Top 4448NP-12 4448NP-6M 4448NP-12M Two Door Mega Top 4448NP-18M 4460NP-8 Two Door Salad Top 4460NP-12...

General Information Model Description D4464NP-18M Four Drawer Mega Top D4464NP-24M D4472NP-12 Six Drawer Salad Top D4472NP-18 D4472NP-18M D4472NP-24M Six Drawer Mega Top D4472NP-30M Refrigerated Front Breathers With Doors & 4” S/S Backsplash ST4427NP-6 One Door Salad Top ST4427NP-8 ST4448NP-6 ST4448NP-8 Two Door Salad Top ST4460NP-8 ST4460NP-12 ST4448NP-6M ST4448NP-12M Two Door Mega Top ST4460NP-12M ST4460NP-18M ST4464NP-8 Two Door Salad Top ST4464NP-12 ST4464NP-12M Two Door Mega Top ST4464NP-18M ST4472NP-12 Three Door Salad Top ST4472NP-18M Three Door Mega Top ST4472NP-24M Refrigerated...

Section 2 Installation DANGER Installation must comply with all applicable fire and health codes in your jurisdiction. DANGER Use appropriate safety equipment during installation and servicing. nWarning Do not damage the refrigeration circuit when installing, maintaining or servicing the unit. The location selected for the equipment must meet the following criteria. If any of these criteria are not met, select another location. • Units are intended for indoor use only. • The location MUST be level, stable and capable of supporting the weight of the equipment. • The location MUST be free...

Weight of Equipment Model Ship Weight Refrigerated Front Breathers With Doors 223lbs (101kg) 240lbs (109kg)

Clearance Requirements • Keep the vents clean and free of obstruction. • Casters or optional legs must be used and not removed. • Provide good air circulation inside and outside the cabinet. • Do not pack refrigerator so full that air cannot circulate. • Avoid hot corners and locations near stoves and ovens. • These cabinets have Delfield’s “front-breathing” design. They may be installed flush against a wall or built into a counter as required. ,Caution Any restriction of the proper air flow outlined above, total or partial, will void the warranty on the cabinet. Dimensions Model Length...

Electrical Service DANGER Check all wiring connections, including factory terminals, before operation. Connections can become loose during shipment and installation. nWarning This appliance must be grounded and all field wiring must conform to all applicable local and national codes. Refer to rating plate for proper voltage. It is the responsibility of the end user to provide the disconnect means to satisfy the authority having jurisdiction. • The Danfoss control can be used to power down and shut off the unit. • All electrical work, including wire routing and grounding, must conform to...

Voltage, Cycle, Phase NEMA Plug Drain Connections nWarning Moisture collecting from improper drainage can create a slippery surface on the floor and a hazard to employees. It is the owner’s responsibility to provide a container or outlet for drainage. Self-contained models are standard with a condensate evaporator. If, for some reason, a cabinet does not have a condensate evaporator, or the evaporator fails, the cabinets drain must have an outlet to an appropriate drainage area or container.

Refrigeration Model BTU/Hour Heat of R290 Charge Capacity Rejection Refrigerated Front Breathers With Doors

Level & Stable After the cabinet has been placed in the desired location, cabinets with legs must be leveled. Level units from front to back and from side to side. Leveling will insure proper door operation and removal of condensate. It is very important that all legs are properly adjusted to keep the cabinet level, evenly distribute the weight and to make sure the unit will not rock, lean or be unstable. If additional pan temperature cooling ability is desired, especially in higher ambient temperature conditions and/ or if pan covers are open or off for extended time periods improved...

Section 2 If the overshelf was not ordered with the unit: 1. Set the overshelf in-place on the top of the cabinet. 2. Secure with three screws per side of the cabinet (total six screws). Optional Overshelf Installation Instructions If the unit is ordered to have the overshelf: 1. Remove the three screws from each top side of the cabinet (total six screws). 2. Set the overshelf in-place on the top of the cabinet. 3. Line up the overshelf holes with the unit holes. 4. Secure with three screws per side of the cabinet (total six screws).

Standard Heavy Duty Cutting Board Bracket Mounting Supplies Needed • #3 Phillips Screwdriver Parts Included For 27” & 32” Units Qty Left Bracket Right Bracket Screw, flat head Fender Washer Parts Included For 48” Units Qty Left Bracket Center Bracket Right Bracket Left Bracket Screw, flat head Fender Washer Parts Included For 60”, 64” & 72” Units Qty Left Bracket Center Bracket Right Bracket Screw, flat head Fender Washer Center Bracket Right Bracket