Catalogs >
Decoustics >
Wall Panel Mounting Details

Wall Panel Mounting Details
2Pages

Catalog excerpts

Description Installation shall be in accordance with local code requirements, manufacturers instructions, and as shown on Decoustics approved shop drawings, or detail sheets. Installer shall provide for shimming and adjustments as required to maintain consistent alignment of joints and of finished panel faces, and to ensure unstressed clip / fastening locations. Note: The information provided in this Data Sheet is accurate to the best of our knowledge at the time of printing. However, we reserve the right to make changes when necessary without further notification. Suggested applications may need to be modified to conform with local building codes and conditions. We cannot accept responsibility for products that are not used, or installed, to our specifications. Please refer to our website for most current data. Note: Only handle panels wearing clean, lightweight, white gloves during installation. Follow manufacturer's printed instructions for installation as well as field cutting of panels. Walls Wall Panel Mounting Details Substrate Resin hardened edges & spots Panel clip Wall clip (DWC-7) Finish Panel core Leveling clip Hook and loop fastener Magnetic fastener Steel substrate Adhesive mounting Magnetic 3/16” (5mm) typical Mechanical Hook & Loop Adhesive Panel clip DPC-3 is factory installed as an integral part of mechanically mounted panels. Wall clip DWC-7 is supplied to match DPC-3 panel clip. Clip sizes are 1-1/4” x 7” (32mm x 178 mm) for the full size clip or 1-1’4” x 3-1/2” (32mm x 89 mm) for the half clip. Half clips are used to mount reveal arrangements. Full clips are suitable for butt arrangements.

Open the catalog to page 1

e-mail: sales@www.decoustics.com decoustics.com For LEED, BREEAM, and environmental information, please visit our website’s home page. 06/10 Ceilencio, Claro, Metallo, Quadrillo, Solo and Trelisio are trademarks of Decoustics Limited. Walls Wall Panel Mounting Details Detail at butt Detail at reveal LEVELING ANGLE DLA-96 can be supplied for vertical butt or reveal high level mountings. Continuous angle is covered in a matching finish to that of the panels being supported. LEVELING CLIP DLC-175 is supplied for reveal and butt mountings. Clip 3” (76 mm) long. Leveling clips are fabric covered...

Open the catalog to page 2